enable-active-high;
};
+ reg_mipi_dsi_pwr_on: mipi_dsi_pwr_on {
+ compatible = "regulator-fixed";
+ regulator-name = "mipi_dsi_pwr_on";
+ gpio = <&gpio6 14 0>;
+ enable-active-high;
+ };
+
reg_sensor: regulator@3 {
compatible = "regulator-fixed";
reg = <3>;
power {
label = "Power Button";
- gpios = <&gpio3 29 0>;
+ gpios = <&gpio3 29 1>;
gpio-key,wakeup;
linux,code = <KEY_POWER>;
};
volume-up {
label = "Volume Up";
- gpios = <&gpio1 4 0>;
+ gpios = <&gpio1 4 1>;
gpio-key,wakeup;
linux,code = <KEY_VOLUMEUP>;
};
volume-down {
label = "Volume Down";
- gpios = <&gpio1 5 0>;
+ gpios = <&gpio1 5 1>;
gpio-key,wakeup;
linux,code = <KEY_VOLUMEDOWN>;
};
status = "okay";
};
+ v4l2_cap_0 {
+ compatible = "fsl,imx6q-v4l2-capture";
+ ipu_id = <0>;
+ csi_id = <0>;
+ mclk_source = <0>;
+ status = "okay";
+ };
+
+ v4l2_cap_1 {
+ compatible = "fsl,imx6q-v4l2-capture";
+ ipu_id = <0>;
+ csi_id = <1>;
+ mclk_source = <0>;
+ status = "okay";
+ };
+
v4l2_out {
compatible = "fsl,mxc_v4l2_output";
status = "okay";
};
+
+ mipi_dsi_reset: mipi-dsi-reset {
+ compatible = "gpio-reset";
+ reset-gpios = <&gpio6 11 GPIO_ACTIVE_LOW>;
+ reset-delay-us = <50>;
+ #reset-cells = <0>;
+ };
};
&audmux {
pinctrl-0 = <&pinctrl_enet>;
phy-mode = "rgmii";
phy-reset-gpios = <&gpio1 25 0>;
+ fsl,magic-packet;
status = "okay";
};
interrupts = <18 8>;
interrupt-route = <1>;
};
+
+ ov564x: ov564x@3c {
+ compatible = "ovti,ov564x";
+ reg = <0x3c>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_ipu1_2>;
+ clocks = <&clks IMX6QDL_CLK_CKO>;
+ clock-names = "csi_mclk";
+ DOVDD-supply = <&vgen4_reg>; /* 1.8v */
+ AVDD-supply = <&vgen3_reg>; /* 2.8v, on rev C board is VGEN3,
+ on rev B board is VGEN5 */
+ DVDD-supply = <&vgen2_reg>; /* 1.5v*/
+ pwn-gpios = <&gpio1 16 1>; /* active low: SD1_DAT0 */
+ rst-gpios = <&gpio1 17 0>; /* active high: SD1_DAT1 */
+ csi_id = <0>;
+ mclk = <24000000>;
+ mclk_source = <0>;
+ };
};
&i2c2 {
};
};
};
+
+ ov5640_mipi: ov5640_mipi@3c { /* i2c2 driver */
+ compatible = "ovti,ov5640_mipi";
+ reg = <0x3c>;
+ clocks = <&clks 201>;
+ clock-names = "csi_mclk";
+ DOVDD-supply = <&vgen4_reg>; /* 1.8v */
+ AVDD-supply = <&vgen3_reg>; /* 2.8v, rev C board is VGEN3
+ rev B board is VGEN5 */
+ DVDD-supply = <&vgen2_reg>; /* 1.5v*/
+ pwn-gpios = <&gpio1 19 1>; /* active low: SD1_CLK */
+ rst-gpios = <&gpio1 20 0>; /* active high: SD1_DAT2 */
+ csi_id = <1>;
+ mclk = <24000000>;
+ mclk_source = <0>;
+ };
+
+ egalax_ts@04 {
+ compatible = "eeti,egalax_ts";
+ reg = <0x04>;
+ interrupt-parent = <&gpio6>;
+ interrupts = <8 2>;
+ wakeup-gpios = <&gpio6 8 0>;
+ };
+
};
&i2c3 {
MX6QDL_PAD_NANDF_D3__GPIO2_IO03 0x80000000
MX6QDL_PAD_GPIO_0__CCM_CLKO1 0x130b0
MX6QDL_PAD_NANDF_CLE__GPIO6_IO07 0x80000000
+ MX6QDL_PAD_NANDF_ALE__GPIO6_IO08 0x80000000
MX6QDL_PAD_ENET_TXD1__GPIO1_IO29 0x80000000
MX6QDL_PAD_EIM_D22__GPIO3_IO22 0x80000000
MX6QDL_PAD_ENET_CRS_DV__GPIO1_IO25 0x80000000
MX6QDL_PAD_GPIO_9__GPIO1_IO09 0x80000000
MX6QDL_PAD_EIM_DA9__GPIO3_IO09 0x80000000
MX6QDL_PAD_GPIO_1__WDOG2_B 0x80000000
+ MX6QDL_PAD_NANDF_CS0__GPIO6_IO11 0x80000000
+ MX6QDL_PAD_NANDF_CS1__GPIO6_IO14 0x80000000
>;
};
>;
};
+ pinctrl_ipu1_2: ipu1grp-2 { /* parallel camera */
+ fsl,pins = <
+ MX6QDL_PAD_CSI0_DAT12__IPU1_CSI0_DATA12 0x80000000
+ MX6QDL_PAD_CSI0_DAT13__IPU1_CSI0_DATA13 0x80000000
+ MX6QDL_PAD_CSI0_DAT14__IPU1_CSI0_DATA14 0x80000000
+ MX6QDL_PAD_CSI0_DAT15__IPU1_CSI0_DATA15 0x80000000
+ MX6QDL_PAD_CSI0_DAT16__IPU1_CSI0_DATA16 0x80000000
+ MX6QDL_PAD_CSI0_DAT17__IPU1_CSI0_DATA17 0x80000000
+ MX6QDL_PAD_CSI0_DAT18__IPU1_CSI0_DATA18 0x80000000
+ MX6QDL_PAD_CSI0_DAT19__IPU1_CSI0_DATA19 0x80000000
+ MX6QDL_PAD_CSI0_DATA_EN__IPU1_CSI0_DATA_EN 0x80000000
+ MX6QDL_PAD_CSI0_PIXCLK__IPU1_CSI0_PIXCLK 0x80000000
+ MX6QDL_PAD_CSI0_MCLK__IPU1_CSI0_HSYNC 0x80000000
+ MX6QDL_PAD_CSI0_VSYNC__IPU1_CSI0_VSYNC 0x80000000
+ >;
+ };
+
pinctrl_pwm1: pwm1grp {
fsl,pins = <
MX6QDL_PAD_SD1_DAT3__PWM1_OUT 0x1b0b1
MX6QDL_PAD_SD3_DAT7__SD3_DATA7 0x17059
>;
};
+
+ pinctrl_usdhc4: usdhc4grp {
+ fsl,pins = <
+ MX6QDL_PAD_SD4_CMD__SD4_CMD 0x17059
+ MX6QDL_PAD_SD4_CLK__SD4_CLK 0x10059
+ MX6QDL_PAD_SD4_DAT0__SD4_DATA0 0x17059
+ MX6QDL_PAD_SD4_DAT1__SD4_DATA1 0x17059
+ MX6QDL_PAD_SD4_DAT2__SD4_DATA2 0x17059
+ MX6QDL_PAD_SD4_DAT3__SD4_DATA3 0x17059
+ MX6QDL_PAD_SD4_DAT4__SD4_DATA4 0x17059
+ MX6QDL_PAD_SD4_DAT5__SD4_DATA5 0x17059
+ MX6QDL_PAD_SD4_DAT6__SD4_DATA6 0x17059
+ MX6QDL_PAD_SD4_DAT7__SD4_DATA7 0x17059
+ >;
+ };
+
};
};
};
};
+&mipi_csi {
+ status = "okay";
+ ipu_id = <0>;
+ csi_id = <1>;
+ v_channel = <0>;
+ lanes = <2>;
+};
+
+&mipi_dsi {
+ dev_id = <0>;
+ disp_id = <1>;
+ lcd_panel = "TRULY-WVGA";
+ disp-power-on-supply = <®_mipi_dsi_pwr_on>;
+ resets = <&mipi_dsi_reset>;
+ status = "okay";
+};
+
+&pcie {
+ power-on-gpio = <&gpio3 19 0>;
+ reset-gpio = <&gpio7 12 0>;
+ status = "okay";
+};
+
&pwm1 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_pwm1>;
bus-width = <8>;
cd-gpios = <&gpio2 2 0>;
wp-gpios = <&gpio2 3 0>;
+ no-1-8-v;
+ keep-power-in-suspend;
+ enable-sdio-wakeup;
status = "okay";
};
bus-width = <8>;
cd-gpios = <&gpio2 0 0>;
wp-gpios = <&gpio2 1 0>;
+ no-1-8-v;
+ keep-power-in-suspend;
+ enable-sdio-wakeup;
+ status = "okay";
+};
+
+&usdhc4 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_usdhc4>;
+ bus-width = <8>;
+ non-removable;
+ no-1-8-v;
+ keep-power-in-suspend;
+ status = "okay";
+};
+
+&wdog1 {
+ status = "disabled";
+};
+
+&wdog2 {
status = "okay";
};
projects / karo-tx-linux.git / blobdiff