return 0;
}
-/* TODO: implement the I2C deblocking function */
-int i2c_make_abort(void)
+/* I2C deblocking uses the algorithm defined in board/keymile/common/common.c
+ * 2 dedicated QRIO GPIOs externally pull the SCL and SDA lines
+ * For I2C only the low state is activly driven and high state is pulled-up
+ * by a resistor. Therefore the deblock GPIOs are used
+ * -> as an active output to drive a low state
+ * -> as an open-drain input to have a pulled-up high state
+ */
+
+/* QRIO GPIOs used for deblocking */
+#define DEBLOCK_PORT1 GPIO_A
+#define DEBLOCK_SCL1 20
+#define DEBLOCK_SDA1 21
+
+/* By default deblock GPIOs are floating */
+static void i2c_deblock_gpio_cfg(void)
+{
+ /* set I2C bus 1 deblocking GPIOs input, but 0 value for open drain */
+ qrio_gpio_direction_input(DEBLOCK_PORT1, DEBLOCK_SCL1);
+ qrio_gpio_direction_input(DEBLOCK_PORT1, DEBLOCK_SDA1);
+
+ qrio_set_gpio(DEBLOCK_PORT1, DEBLOCK_SCL1, 0);
+ qrio_set_gpio(DEBLOCK_PORT1, DEBLOCK_SDA1, 0);
+}
+
+void set_sda(int state)
+{
+ qrio_set_opendrain_gpio(DEBLOCK_PORT1, DEBLOCK_SDA1, state);
+}
+
+void set_scl(int state)
+{
+ qrio_set_opendrain_gpio(DEBLOCK_PORT1, DEBLOCK_SCL1, state);
+}
+
+int get_sda(void)
+{
+ return qrio_get_gpio(DEBLOCK_PORT1, DEBLOCK_SDA1);
+}
+
+int get_scl(void)
{
- return 1;
+ return qrio_get_gpio(DEBLOCK_PORT1, DEBLOCK_SCL1);
}
+
#define ZL30158_RST 8
#define ZL30343_RST 9
int board_early_init_r(void)
{
+ int ret = 0;
/* Flush d-cache and invalidate i-cache of any FLASH data */
flush_dcache();
invalidate_icache();
set_liodns();
setup_portals();
- return 0;
+ ret = trigger_fpga_config();
+ if (ret)
+ printf("error triggering PCIe FPGA config\n");
+
+ return ret;
}
unsigned long get_board_sys_clk(unsigned long dummy)
return 66666666;
}
+int misc_init_f(void)
+{
+ /* configure QRIO pis for i2c deblocking */
+ i2c_deblock_gpio_cfg();
+
+ return 0;
+}
+
#define NUM_SRDS_BANKS 2
#define PHY_RST 15