]> git.kernelconcepts.de Git - karo-tx-uboot.git/blobdiff - include/configs/stxgp3.h
ARM: tegra: p2571: remove another unused define
[karo-tx-uboot.git] / include / configs / stxgp3.h
index ee1f1f3ed00829c04ce5ef1f2ee809fa43ecd99d..6676f373f2f67525fe0e3e8712fb8f06ad240378 100644 (file)
@@ -13,7 +13,7 @@
 /* mpc8560ads board configuration file */
 /* please refer to doc/README.mpc85xx for more info */
 /* make sure you change the MAC address and other network params first,
- * search for CONFIG_ETHADDR,CONFIG_SERVERIP,etc in this file
+ * search for CONFIG_SERVERIP, etc. in this file
  */
 
 #ifndef __CONFIG_H
@@ -22,7 +22,6 @@
 /* High Level Configuration Options */
 #define CONFIG_BOOKE           1       /* BOOKE                */
 #define CONFIG_E500            1       /* BOOKE e500 family    */
-#define CONFIG_MPC85xx         1       /* MPC8540/MPC8560      */
 #define CONFIG_CPM2            1       /* has CPM2 */
 #define CONFIG_STXGP3          1       /* Silicon Tx GPPP board specific*/
 #define CONFIG_MPC8560         1
 /*
  * Command line configuration.
  */
-#include <config_cmd_default.h>
-
 #define CONFIG_CMD_PING
 #define CONFIG_CMD_I2C
 #define CONFIG_CMD_REGINFO
 
-#if defined(CONFIG_SYS_RAMBOOT)
-    #undef CONFIG_CMD_SAVEENV
-    #undef CONFIG_CMD_LOADS
-#else
+#if !defined(CONFIG_SYS_RAMBOOT)
     #define CONFIG_CMD_ELF
 #endif
 
 
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed to run kgdb serial port */
-#define CONFIG_KGDB_SER_INDEX  2       /* which serial port to use */
 #endif
 
-/*Note: change below for your network setting!!! */
 #if defined(CONFIG_TSEC_ENET) || defined(CONFIG_ETHER_ON_FCC)
 #define CONFIG_HAS_ETH0
-#define CONFIG_ETHADDR          00:e0:0c:07:9b:8a
 #define CONFIG_HAS_ETH1
-#define CONFIG_ETH1ADDR                 00:e0:0c:07:9b:8b
 #define CONFIG_HAS_ETH2
-#define CONFIG_ETH2ADDR                 00:e0:0c:07:9b:8c
 #endif
 
 #define CONFIG_SERVERIP                192.168.85.1