Fix bus width switching from 8-bit mode down to 4-bit or 1-bit modes on
Samsung SoCs using SDHCI_QUIRK_USE_WIDE8. These SoCs report controller
version 2.0 yet they support 8-bit bus widths. If 8-bit mode was
previously enabled and then an operation like "mmc dev" caused a switch
back down to 4-bit or 1-bit mode, WIDE8 was left set, causing failures.
This problem was manifested by "mmc dev" timing out.
Signed-off-by: Matt Reimer <mreimer@sdgsystems.com>
(host->quirks & SDHCI_QUIRK_USE_WIDE8))
ctrl |= SDHCI_CTRL_8BITBUS;
} else {
- if (SDHCI_GET_VERSION(host) >= SDHCI_SPEC_300)
+ if ((SDHCI_GET_VERSION(host) >= SDHCI_SPEC_300) ||
+ (host->quirks & SDHCI_QUIRK_USE_WIDE8))
ctrl &= ~SDHCI_CTRL_8BITBUS;
if (mmc->bus_width == 4)
ctrl |= SDHCI_CTRL_4BITBUS;