Required properties:
- compatible : should be one of
+ "apm,potenza-pmu"
"arm,armv8-pmuv3"
+ "arm.cortex-a57-pmu"
+ "arm.cortex-a53-pmu"
"arm,cortex-a17-pmu"
"arm,cortex-a15-pmu"
"arm,cortex-a12-pmu"
- interrupt-parent: Specifies the phandle of the interrupt controller to which
the interrupts from s2mps11 are delivered to.
- interrupts: Interrupt specifiers for interrupt sources.
+- samsung,s2mps11-wrstbi-ground: Indicates that WRSTBI pin of PMIC is pulled
+ down. When the system is suspended it will always go down thus triggerring
+ unwanted buck warm reset (setting buck voltages to default values).
+ - samsung,s2mps11-acokb-ground: Indicates that ACOKB pin of S2MPS11 PMIC is
+ connected to the ground so the PMIC must manually set PWRHOLD bit in CTRL1
+ register to turn off the power. Usually the ACOKB is pulled up to VBATT so
+ when PWRHOLD pin goes low, the rising ACOKB will trigger power off.
Optional nodes:
-- clocks: s2mps11, s2mps13 and s5m8767 provide three(AP/CP/BT) buffered 32.768
+- clocks: s2mps11, s2mps13, s2mps15 and s5m8767 provide three(AP/CP/BT) buffered 32.768
KHz outputs, so to register these as clocks with common clock framework
instantiate a sub-node named "clocks". It uses the common clock binding
documented in :
phytec PHYTEC Messtechnik GmbH
picochip Picochip Ltd
plathome Plat'Home Co., Ltd.
+ plda PLDA
pixcir PIXCIR MICROELECTRONICS Co., Ltd
+pulsedlight PulsedLight, Inc
powervr PowerVR (deprecated, use img)
qca Qualcomm Atheros, Inc.
qcom Qualcomm Technologies, Inc
toshiba Toshiba Corporation
toumaz Toumaz
tplink TP-LINK Technologies Co., Ltd.
+ tronfy Tronfy
truly Truly Semiconductors Limited
+upisemi uPI Semiconductor Corp.
usi Universal Scientific Industrial Co., Ltd.
v3 V3 Semiconductor
variscite Variscite Ltd.
status = "disabled";
};
+ pioA: pinctrl@fc038000 {
+ compatible = "atmel,sama5d2-pinctrl";
+ reg = <0xfc038000 0x600>;
+ interrupts = <18 IRQ_TYPE_LEVEL_HIGH 7>,
+ <68 IRQ_TYPE_LEVEL_HIGH 7>,
+ <69 IRQ_TYPE_LEVEL_HIGH 7>,
+ <70 IRQ_TYPE_LEVEL_HIGH 7>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ clocks = <&pioA_clk>;
+ };
++
+ tdes@fc044000 {
+ compatible = "atmel,at91sam9g46-tdes";
+ reg = <0xfc044000 0x100>;
+ interrupts = <11 IRQ_TYPE_LEVEL_HIGH 0>;
+ dmas = <&dma0
+ (AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1) |
+ AT91_XDMAC_DT_PERID(28))>,
+ <&dma0
+ (AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1) |
+ AT91_XDMAC_DT_PERID(29))>;
+ dma-names = "tx", "rx";
+ clocks = <&tdes_clk>;
+ clock-names = "tdes_clk";
+ status = "okay";
+ };
};
};
};
clock-names = "pwm";
clocks = <&clk_sysin>;
st,pwm-num-chan = <4>;
+
+ status = "disabled";
+ };
+
+ rng10: rng@08a89000 {
+ compatible = "st,rng";
+ reg = <0x08a89000 0x1000>;
+ clocks = <&clk_sysin>;
+ status = "okay";
+ };
+
+ rng11: rng@08a8a000 {
+ compatible = "st,rng";
+ reg = <0x08a8a000 0x1000>;
+ clocks = <&clk_sysin>;
+ status = "okay";
+ };
+
+ ethernet0: dwmac@9630000 {
+ device_type = "network";
+ status = "disabled";
+ compatible = "st,stih407-dwmac", "snps,dwmac", "snps,dwmac-3.710";
+ reg = <0x9630000 0x8000>, <0x80 0x4>;
+ reg-names = "stmmaceth", "sti-ethconf";
+
+ st,syscon = <&syscfg_sbc_reg 0x80>;
+ st,gmac_en;
+ resets = <&softreset STIH407_ETH1_SOFTRESET>;
+ reset-names = "stmmaceth";
+
+ interrupts = <GIC_SPI 98 IRQ_TYPE_NONE>,
+ <GIC_SPI 99 IRQ_TYPE_NONE>;
+ interrupt-names = "macirq", "eth_wake_irq";
+
+ /* DMA Bus Mode */
+ snps,pbl = <8>;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_rgmii1>;
+
+ clock-names = "stmmaceth", "sti-ethclk";
+ clocks = <&clk_s_c0_flexgen CLK_EXT2F_A9>,
+ <&clk_s_c0_flexgen CLK_ETH_PHY>;
};
+
+ rng10: rng@08a89000 {
+ compatible = "st,rng";
+ reg = <0x08a89000 0x1000>;
+ clocks = <&clk_sysin>;
+ status = "okay";
+ };
+
+ rng11: rng@08a8a000 {
+ compatible = "st,rng";
+ reg = <0x08a8a000 0x1000>;
+ clocks = <&clk_sysin>;
+ status = "okay";
+ };
};
};
CONFIG_ARCH_ZYNQMP=y
CONFIG_PCI=y
CONFIG_PCI_MSI=y
+ CONFIG_PCI_HOST_GENERIC=y
CONFIG_PCI_XGENE=y
CONFIG_SMP=y
+CONFIG_SCHED_MC=y
CONFIG_PREEMPT=y
CONFIG_KSM=y
CONFIG_TRANSPARENT_HUGEPAGE=y
projects / karo-tx-linux.git / commitdiff