karo: tx6: fix duplicate const error
karo: tx6: disable Heartbeat LED in case of error
karo: tx6: configure all relevant PMIC registers
karo: tx6: make pixelclock overridable via DT or 'video_mode'
karo: tx6: change drive strength of Ethernet related pads to improve EMC EMC measurements have revealed excessive noise at multiples of the 50MHz ethernet reference clock on TX6 modules. Changing the drive strength of the ENET_REF_CLK pad vastly reduces this noise and improves the signal waveform substanitally. On TXUL also the MDC and MDIO pads contribute to this noise, since they are routed off-board for connecting an optional second ethernet PHY. Adjusting the drive strength for those pads on the TXUL modules also improves the signal quality and reduces EMI.
karo: tx6: indentation cleanup
karo: tx6: cleanup i2c_recover implementation Bring the tx6qdl i2c_recover implementation in sync with the tx6ul version.
board: karo: add support for using Linux simple-panel LCD driver Provide support for updating the 'compatible' property of the simple-panel DT node according to the LCD timing selected via the 'video_mode' variable.
karo: tx6: use GP1 fuse for MIPI variant detection
karo: tx6: support MIPI variant in board name The TX6Q-1230 is physically the same as TX6Q-1030 with the distinction, that the MIPI interface is used rather than the LCD interface. This is only a cosmetic change to adjust the displayed board name.
karo: tx6: configure PMIC to a consistent state upon boot
karo: tx6: remove obsolete TX6Q-1020
karo: tx6: remove unreachable 'return' statements
karo: tx6: configure all pads with explicit pad_ctl values
karo: tx6: add support for TX6Q-8037 (i.MX6QP)
karo: tx6: add support for boards with >= 2GiB memory
karo: tx6: replace open coded interpretation of cpurev by calls to is_cpu_type()
karo: tx6: set LCD x, y dimensions to 0 when disabling LCD Even when the LCD is disabled, the LCD framework will still clear the video memory. This can take a cosiderable amount of time for the maximum resolution of 16MiB that the i.MX6 supports. Setting vl_row and vl_col to 0 results in a zero sized framebuffer to avoid this unnecessary delay.
Merge branch 'tx6-update-2016-02-03' into karo-tx6
karo: tx6: check ctrlc before returning error code for unsupported baseboard