karo: tx6: increase SYS_BOOTM_LEN to 32MiB
enable filesystem agnostic read/write/ls commands
karo: tx6: enable GPT command
karo: tx6: enable raw initrd support
karo: tx6: prevent DTB from either being out of reach of kernel or overwritten during uncompress The current setting of fdtaddr and fdt_high has proven to be inappropriate in that either the FDT may be out of reach of the kernel or may be overwritten by the uncompressing Linux kernel. Set fdt_high to an offset of 256MiB from SDRAM start, so that it is valid for any board regardless of memory size while preventing the described problems.
karo: tx6: add support for Ka-Ro TX6UL-8013
karo: tx6: remove obsolete TX6Q-1020
Merge branch 'tx6-bugfix'
karo: tx6ul: enable soft i2c driver and 'i2c' command
Merge branch 'tx28-update' into tx28-bugfix
karo: tx6ul: disable the PMIC for '_noenv' U-Boot The I2C access to the PMIC requires the TAMPER pins of the i.MX6UL to be useable as GPIOs. This is only possible after the TAMPER_PIN_DISABLE fuses are programmed which is usually done via U-Boot. Resolve this catch 22 situation by disabling the PMIC in the '_noenv' U-Boot variant which is usually used in the manufacturing environment.
karo: tx6: add support for boards with >= 2GiB memory
karo: tx6: rename CONFIG_SYS_BOOT_CMD_NAND to FDTSAVE_CMD_STR This macro in not actually a configurable setting as the original naming suggests.
karo: tx6: remove redundant #ifndef CONFIG_TX6_UBOOT_MFG
net: fec_mxc: make base_mii configurable
ARM: imx6ul: add support for mxsfb on i.MX6UL
karo: tx6: enable CONFIG_BMP_*BPP to make splashscreen functional again
karo: tx6ul: enable soft_i2c for PMIC access
karo: tx6: add TXUL support
karo: tx6: eliminate PHYS_SDRAM_1_WIDTH and use CONFIG_SYS_SDRAM_BUS_WIDTH instead