- cpu/mpc8260 Files specific to Motorola MPC8260 CPU
- cpu/ppc4xx Files specific to IBM 4xx CPUs
+- board/LEOX/ Files specific to boards manufactured by The LEOX team
+- board/LEOX/elpt860 Files specific to ELPT860 boards
- board/RPXClassic
Files specific to RPXClassic boards
- board/RPXlite Files specific to RPXlite boards
CONFIG_GTH, CONFIG_RPXClassic, CONFIG_rsdproto,
CONFIG_IAD210, CONFIG_RPXlite, CONFIG_sbc8260,
CONFIG_EBONY, CONFIG_sacsng, CONFIG_FPS860L,
- CONFIG_V37
+ CONFIG_V37, CONFIG_ELPT860
ARM based boards:
-----------------
CONFIG_RTC_MPC8xx - use internal RTC of MPC8xx
CONFIG_RTC_PCF8563 - use Philips PCF8563 RTC
CONFIG_RTC_MC146818 - use MC146818 RTC
+ CONFIG_RTC_DS1307 - use Maxim, Inc. DS1307 RTC
CONFIG_RTC_DS1337 - use Maxim, Inc. DS1337 RTC
+ CONFIG_RTC_DS164x - use Dallas DS164x RTC
- Timestamp Support:
controls the rate of data transfer. The data rate thus
is 1 / (I2C_DELAY * 4).
+ CFG_I2C_INIT_BOARD
+
+ When a board is reset during an i2c bus transfer
+ chips might think that the current transfer is still
+ in progress. On some boards it is possible to access
+ the i2c SCLK line directly, either by using the
+ processor pin as a GPIO or by having a second pin
+ connected to the bus. If this option is defined a
+ custom i2c_init_board() routine in boards/xxx/board.c
+ is run early in the boot sequence.
+
- SPI Support: CONFIG_SPI
Enables SPI driver (so far only tested with
If CONFIG_ENV_OVERWRITE is #defined in your config
file, the write protection for vendor parameters is
- completely disabled. Anybody can change or delte
+ completely disabled. Anybody can change or delete
these parameters.
Alternatively, if you #define _both_ CONFIG_ETHADDR
FPS850L_config Sandpoint8240_config sbc8260_config
GENIETV_config TQM823L_config PIP405_config
GEN860T_config EBONY_config FPS860L_config
+ ELPT860_config
Note: for some board special configuration names may exist; check if
additional information is available from the board vendor; for