{
/* Address of boot parameters */
gd->bd->bi_boot_params = PHYS_SDRAM_1 + 0x1000;
+
+ if (ctrlc() || (wrsr & WRSR_TOUT)) {
+ printf("CTRL-C detected; Skipping boot critical setup\n");
+ return 1;
+ }
return 0;
}
},
};
-#define to_tx51_esdhc_cfg(p) container_of(p, struct tx51_esdhc_cfg, cfg)
+static inline struct tx51_esdhc_cfg *to_tx51_esdhc_cfg(struct fsl_esdhc_cfg *cfg)
+{
+ return container_of(cfg, struct tx51_esdhc_cfg, cfg);
+}
int board_mmc_getcd(struct mmc *mmc)
{
cfg->num_pads);
cfg->cfg.sdhc_clk = mxc_get_clock(MXC_ESDHC_CLK);
- fsl_esdhc_initialize(bis, &cfg->cfg);
-
ret = gpio_request_one(cfg->cd_gpio,
GPIOF_INPUT, "MMC CD");
if (ret) {
continue;
}
+ debug("%s: Initializing MMC slot %d\n", __func__, i);
+ fsl_esdhc_initialize(bis, &cfg->cfg);
+
mmc = find_mmc_device(i);
if (mmc == NULL)
continue;
ret = cpu_eth_init(bis);
if (ret)
printf("cpu_eth_init() failed: %d\n", ret);
+
return ret;
}
#endif /* CONFIG_FEC_MXC */
};
#ifdef CONFIG_LCD
+static u16 tx51_cmap[256];
vidinfo_t panel_info = {
/* set to max. size supported by SoC */
.vl_col = 1600,
.vl_row = 1200,
.vl_bpix = LCD_COLOR24, /* Bits per pixel, 0: 1bpp, 1: 2bpp, 2: 4bpp, 3: 8bpp ... */
+ .cmap = tx51_cmap,
};
static struct fb_videomode tx51_fb_modes[] = {
void lcd_ctrl_init(void *lcdbase)
{
int color_depth = 24;
- char *vm;
+ const char *video_mode = karo_get_vmode(getenv("video_mode"));
+ const char *vm;
unsigned long val;
int refresh = 60;
struct fb_videomode *p = &tx51_fb_modes[0];
struct fb_videomode fb_mode;
int xres_set = 0, yres_set = 0, bpp_set = 0, refresh_set = 0;
- int pix_fmt = 0;
+ int pix_fmt;
+ int lcd_bus_width;
ipu_di_clk_parent_t di_clk_parent = DI_PCLK_PLL3;
unsigned long di_clk_rate = 65000000;
return;
}
- if (tstc() || (wrsr & WRSR_TOUT)) {
+ if (had_ctrlc() || (wrsr & WRSR_TOUT)) {
debug("Disabling LCD\n");
lcd_enabled = 0;
setenv("splashimage", NULL);
karo_fdt_move_fdt();
lcd_bl_polarity = karo_fdt_get_backlight_polarity(working_fdt);
- vm = getenv("video_mode");
- if (vm == NULL) {
+ if (video_mode == NULL) {
debug("Disabling LCD\n");
lcd_enabled = 0;
return;
}
- if (karo_fdt_get_fb_mode(working_fdt, vm, &fb_mode) == 0) {
+ vm = video_mode;
+ if (karo_fdt_get_fb_mode(working_fdt, video_mode, &fb_mode) == 0) {
p = &fb_mode;
debug("Using video mode from FDT\n");
vm += strlen(vm);
break;
default:
- if (!pix_fmt) {
- char *tmp;
-
- pix_fmt = IPU_PIX_FMT_RGB24;
- tmp = strchr(vm, ':');
- if (tmp)
- vm = tmp;
- }
if (*vm != '\0')
vm++;
}
p->pixclock = KHZ2PICOS(refresh *
(p->xres + p->left_margin + p->right_margin + p->hsync_len) *
- (p->yres + p->upper_margin + p->lower_margin + p->vsync_len)
- / 1000);
+ (p->yres + p->upper_margin + p->lower_margin + p->vsync_len) /
+ 1000);
debug("Pixel clock set to %lu.%03lu MHz\n",
PICOS2KHZ(p->pixclock) / 1000,
PICOS2KHZ(p->pixclock) % 1000);
if (p != &fb_mode) {
int ret;
- char *modename = getenv("video_mode");
- printf("Creating new display-timing node from '%s'\n",
- modename);
- ret = karo_fdt_create_fb_mode(working_fdt, modename, p);
+ debug("Creating new display-timing node from '%s'\n",
+ video_mode);
+ ret = karo_fdt_create_fb_mode(working_fdt, video_mode, p);
if (ret)
printf("Failed to create new display-timing node from '%s': %d\n",
- modename, ret);
+ video_mode, ret);
}
gpio_request_array(stk5_lcd_gpios, ARRAY_SIZE(stk5_lcd_gpios));
imx_iomux_v3_setup_multiple_pads(stk5_lcd_pads,
ARRAY_SIZE(stk5_lcd_pads));
- debug("Initializing FB driver\n");
- if (!pix_fmt)
+ lcd_bus_width = karo_fdt_get_lcd_bus_width(working_fdt, 24);
+ switch (lcd_bus_width) {
+ case 24:
pix_fmt = IPU_PIX_FMT_RGB24;
+ break;
+
+ case 18:
+ pix_fmt = IPU_PIX_FMT_RGB666;
+ break;
+
+ case 16:
+ pix_fmt = IPU_PIX_FMT_RGB565;
+ break;
+ default:
+ lcd_enabled = 0;
+ printf("Invalid LCD bus width: %d\n", lcd_bus_width);
+ return;
+ }
if (karo_load_splashimage(0) == 0) {
int ret;
struct mxc_ccm_reg *ccm_regs = (struct mxc_ccm_reg *)MXC_CCM_BASE;
static void tx51_set_cpu_clock(void)
{
unsigned long cpu_clk = getenv_ulong("cpu_clk", 10, 0);
- int ret;
- if (tstc() || (wrsr & WRSR_TOUT))
+ if (had_ctrlc() || (wrsr & WRSR_TOUT))
return;
if (cpu_clk == 0 || cpu_clk == mxc_get_clock(MXC_ARM_CLK) / 1000000)
return;
- ret = mxc_set_clock(CONFIG_SYS_MX5_HCLK, cpu_clk, MXC_ARM_CLK);
- if (ret != 0) {
+ if (mxc_set_clock(CONFIG_SYS_MX5_HCLK, cpu_clk, MXC_ARM_CLK) == 0) {
+ cpu_clk = mxc_get_clock(MXC_ARM_CLK);
+ printf("CPU clock set to %lu.%03lu MHz\n",
+ cpu_clk / 1000000, cpu_clk / 1000 % 1000);
+ } else {
printf("Error: Failed to set CPU clock to %lu MHz\n", cpu_clk);
- return;
}
- printf("CPU clock set to %u.%03u MHz\n",
- mxc_get_clock(MXC_ARM_CLK) / 1000000,
- mxc_get_clock(MXC_ARM_CLK) / 1000 % 1000);
}
static void tx51_init_mac(void)
return;
}
- eth_setenv_enetaddr("ethaddr", mac);
printf("MAC addr from fuse: %pM\n", mac);
+ eth_setenv_enetaddr("ethaddr", mac);
}
int board_late_init(void)
if (!baseboard)
goto exit;
+ printf("Baseboard: %s\n", baseboard);
+
if (strncmp(baseboard, "stk5", 4) == 0) {
- printf("Baseboard: %s\n", baseboard);
if ((strlen(baseboard) == 4) ||
strcmp(baseboard, "stk5-v3") == 0) {
stk5v3_board_init();
exit:
tx51_init_mac();
+
gpio_set_value(TX51_RESET_OUT_GPIO, 1);
+ clear_ctrlc();
return ret;
}
#ifdef CONFIG_FDT_FIXUP_PARTITIONS
#include <jffs2/jffs2.h>
#include <mtd_node.h>
-struct node_info nodes[] = {
+static struct node_info nodes[] = {
{ "fsl,imx51-nand", MTD_DEV_TYPE_NAND, },
};
-
#else
#define fdt_fixup_mtdparts(b,n,c) do { } while (0)
#endif
void ft_board_setup(void *blob, bd_t *bd)
{
+ const char *video_mode = karo_get_vmode(getenv("video_mode"));
+ int ret;
+
+ ret = fdt_increase_size(blob, 4096);
+ if (ret)
+ printf("Failed to increase FDT size: %s\n", fdt_strerror(ret));
+
fdt_fixup_mtdparts(blob, nodes, ARRAY_SIZE(nodes));
fdt_fixup_ethernet(blob);
karo_fdt_fixup_touchpanel(blob, tx51_touchpanels,
ARRAY_SIZE(tx51_touchpanels));
- karo_fdt_fixup_usb_otg(blob, "fsl,imx-otg", "fsl,usbphy");
- karo_fdt_update_fb_mode(blob, getenv("video_mode"));
+ karo_fdt_fixup_usb_otg(blob, "usbotg", "fsl,usbphy");
+ karo_fdt_update_fb_mode(blob, video_mode);
}
-#endif
+#endif /* CONFIG_OF_BOARD_SETUP */
projects / karo-tx-uboot.git / blobdiff