* Patches by Xianghua Xiao, 15 Oct 2003:

[karo-tx-uboot.git] / board / sacsng / sacsng.c

diff --git a/board/sacsng/sacsng.c b/board/sacsng/sacsng.c
index 60563d4ab2b151b89c02521c1f9ec7bb1cab71e5..e50b7479238f5e758f8c2410da37b3847bbca6d3 100644 (file)
--- a/board/sacsng/sacsng.c
+++ b/board/sacsng/sacsng.c
@@ -533,11 +533,11 @@ int misc_init_r(void)
        setenv("Daq128xSampling", "1");
     }
 
-    /* 
-     * Display the ADC/DAC clocking information 
+    /*
+     * Display the ADC/DAC clocking information
      */
     if (!quiet) {
-        Daq_Display_Clocks();
+       Daq_Display_Clocks();
     }
 
     /*
@@ -572,9 +572,9 @@ int misc_init_r(void)
      * 3) Write the I2C address to register 6
      * 4) Enable address matching by setting the MSB in register 7
      */
-    
+
     if (!quiet) {
-        printf("Initializing the ADC...\n");
+       printf("Initializing the ADC...\n");
     }
     udelay(ADC_INITIAL_DELAY);         /* 10uSec per uF of VREF cap */
 
@@ -720,7 +720,7 @@ int misc_init_r(void)
     I2C_TRISTATE;
 
     if (!quiet) {
-        printf("\n");
+       printf("\n");
     }
 
 #ifdef CONFIG_ETHER_LOOPBACK_TEST
@@ -795,14 +795,14 @@ void show_boot_progress (int status)
     if(status > 0) {
        last_boot_progress = status;
     } else {
-        /* 
+       /*
         * If a specific failure code is given, flash this code
         * else just use the last success code we've seen
         */
        if(status < -1)
            last_boot_progress = -status;
-       
-       /* 
+
+       /*
         * Flash this code 5 times
         */
        for(j=0; j<5; j++) {
@@ -813,15 +813,15 @@ void show_boot_progress (int status)
            status_led_set(STATUS_LED_RED, STATUS_LED_ON);
            flash_code(last_boot_progress, 5, 3);
 
-           /* 
-            * Delay 5 seconds between repetitions, 
-            * with the fault LED blinking 
+           /*
+            * Delay 5 seconds between repetitions,
+            * with the fault LED blinking
             */
            for(i=0; i<5; i++) {
-               status_led_set(STATUS_LED_RED, STATUS_LED_OFF);
-               udelay(500000);
-               status_led_set(STATUS_LED_RED, STATUS_LED_ON);
-               udelay(500000);
+               status_led_set(STATUS_LED_RED, STATUS_LED_OFF);
+               udelay(500000);
+               status_led_set(STATUS_LED_RED, STATUS_LED_ON);
+               udelay(500000);
            }
        }