#include <command.h>
#include "karef.h"
#include "karef_version.h"
+#include <timestamp.h>
#include <asm/processor.h>
#include <asm/io.h>
#include <spd_sdram.h>
#include <i2c.h>
#include "../common/sb_common.h"
#include "../common/ppc440gx_i2c.h"
+#if defined(CONFIG_HAS_ETH0) || defined(CONFIG_HAS_ETH1) || \
+ defined(CONFIG_HAS_ETH2) || defined(CONFIG_HAS_ETH3)
+#include <net.h>
+#endif
void fpga_init (void);
mtsdr(sdr_pfc0, 0x00103E00);
/* Setup access for LEDs, and system topology info */
- gpio_regs = (ppc440_gpio_regs_t *)CFG_GPIO_BASE;
+ gpio_regs = (ppc440_gpio_regs_t *)CONFIG_SYS_GPIO_BASE;
gpio_regs->open_drain = SBCOMMON_GPIO_SYS_LEDS;
gpio_regs->tri_state = SBCOMMON_GPIO_DBGLEDS;
EBC_BXAP_RE_DISABLED | EBC_BXAP_BEM_WRITEONLY |
EBC_BXAP_PEN_DISABLED);
- mtebc(pb0cr, EBC_BXCR_BAS_ENCODE(CFG_FLASH_BASE) |
+ mtebc(pb0cr, EBC_BXCR_BAS_ENCODE(CONFIG_SYS_FLASH_BASE) |
EBC_BXCR_BS_1MB | EBC_BXCR_BU_RW | EBC_BXCR_BW_8BIT);
/*--------------------------------------------------------------------+
| 8KB NVRAM/RTC. Initialize bank 1 with default values.
/*--------------------------------------------------------------------+
* Setup the interrupt controller polarities, triggers, etc.
+-------------------------------------------------------------------*/
- mtdcr (uic0sr, 0xffffffff); /* clear all */
- mtdcr (uic0er, 0x00000000); /* disable all */
- mtdcr (uic0cr, 0x00000000); /* all non- critical */
- mtdcr (uic0pr, 0xfffffe03); /* polarity */
- mtdcr (uic0tr, 0x01c00000); /* trigger edge vs level */
- mtdcr (uic0vr, 0x00000001); /* int31 highest, base=0x000 */
- mtdcr (uic0sr, 0xffffffff); /* clear all */
-
+ /*
+ * Because of the interrupt handling rework to handle 440GX interrupts
+ * with the common code, we needed to change names of the UIC registers.
+ * Here the new relationship:
+ *
+ * U-Boot name 440GX name
+ * -----------------------
+ * UIC0 UICB0
+ * UIC1 UIC0
+ * UIC2 UIC1
+ * UIC3 UIC2
+ */
mtdcr (uic1sr, 0xffffffff); /* clear all */
mtdcr (uic1er, 0x00000000); /* disable all */
- mtdcr (uic1cr, 0x00000000); /* all non-critical */
- mtdcr (uic1pr, 0xffffc8ff); /* polarity */
- mtdcr (uic1tr, 0x00ff0000); /* trigger edge vs level */
+ mtdcr (uic1cr, 0x00000000); /* all non- critical */
+ mtdcr (uic1pr, 0xfffffe03); /* polarity */
+ mtdcr (uic1tr, 0x01c00000); /* trigger edge vs level */
mtdcr (uic1vr, 0x00000001); /* int31 highest, base=0x000 */
mtdcr (uic1sr, 0xffffffff); /* clear all */
mtdcr (uic2sr, 0xffffffff); /* clear all */
mtdcr (uic2er, 0x00000000); /* disable all */
mtdcr (uic2cr, 0x00000000); /* all non-critical */
- mtdcr (uic2pr, 0xffff83ff); /* polarity */
- mtdcr (uic2tr, 0x00ff8c0f); /* trigger edge vs level */
+ mtdcr (uic2pr, 0xffffc8ff); /* polarity */
+ mtdcr (uic2tr, 0x00ff0000); /* trigger edge vs level */
mtdcr (uic2vr, 0x00000001); /* int31 highest, base=0x000 */
mtdcr (uic2sr, 0xffffffff); /* clear all */
- mtdcr (uicb0sr, 0xfc000000); /* clear all */
- mtdcr (uicb0er, 0x00000000); /* disable all */
- mtdcr (uicb0cr, 0x00000000); /* all non-critical */
- mtdcr (uicb0pr, 0xfc000000);
- mtdcr (uicb0tr, 0x00000000);
- mtdcr (uicb0vr, 0x00000001);
+ mtdcr (uic3sr, 0xffffffff); /* clear all */
+ mtdcr (uic3er, 0x00000000); /* disable all */
+ mtdcr (uic3cr, 0x00000000); /* all non-critical */
+ mtdcr (uic3pr, 0xffff83ff); /* polarity */
+ mtdcr (uic3tr, 0x00ff8c0f); /* trigger edge vs level */
+ mtdcr (uic3vr, 0x00000001); /* int31 highest, base=0x000 */
+ mtdcr (uic3sr, 0xffffffff); /* clear all */
+
+ mtdcr (uic0sr, 0xfc000000); /* clear all */
+ mtdcr (uic0er, 0x00000000); /* disable all */
+ mtdcr (uic0cr, 0x00000000); /* all non-critical */
+ mtdcr (uic0pr, 0xfc000000);
+ mtdcr (uic0tr, 0x00000000);
+ mtdcr (uic0vr, 0x00000001);
fpga_init();
KAREF_FPGA_REGS_ST *karef_ps;
OFEM_FPGA_REGS_ST *ofem_ps;
- karef_ps = (KAREF_FPGA_REGS_ST *)CFG_KAREF_FPGA_BASE;
- ofem_ps = (OFEM_FPGA_REGS_ST *)CFG_OFEM_FPGA_BASE;
+ karef_ps = (KAREF_FPGA_REGS_ST *)CONFIG_SYS_KAREF_FPGA_BASE;
+ ofem_ps = (OFEM_FPGA_REGS_ST *)CONFIG_SYS_OFEM_FPGA_BASE;
scan_id = (unsigned char)((karef_ps->revision_ul &
SAND_HAL_KA_SC_SCAN_REVISION_IDENTIFICATION_MASK)
"Serial Number: %d\n", sernum);
printf ("%s\n", KAREF_U_BOOT_REL_STR);
- printf ("Built %s %s by %s\n", __DATE__, __TIME__, BUILDUSER);
+ printf ("Built %s %s by %s\n", U_BOOT_DATE, U_BOOT_TIME, BUILDUSER);
if (sbcommon_get_master()) {
printf("Slot 0 - Master\nSlave board");
if (sbcommon_secondary_present())
/* Fix the ack in the bme 32 */
udelay(5000);
- out32(CFG_BME32_BASE + 0x0000000C, 0x00000001);
+ out32(CONFIG_SYS_BME32_BASE + 0x0000000C, 0x00000001);
asm("eieio");
{
/* Turn on i2c bus 1 */
puts ("I2C1: ");
- i2c1_init (CFG_I2C_SPEED, CFG_I2C_SLAVE);
+ i2c1_init (CONFIG_SYS_I2C_SPEED, CONFIG_SYS_I2C_SLAVE);
puts ("ready\n");
/* Turn on fans 3 & 4 */
{
unsigned short sernum;
char envstr[255];
+ uchar enetaddr[6];
KAREF_FPGA_REGS_ST *karef_ps;
OFEM_FPGA_REGS_ST *ofem_ps;
setenv("ubrelver", KAREF_U_BOOT_REL_STR);
memset(envstr, 0, 255);
- sprintf (envstr, "Built %s %s by %s", __DATE__, __TIME__, BUILDUSER);
+ sprintf (envstr, "Built %s %s by %s",
+ U_BOOT_DATE, U_BOOT_TIME, BUILDUSER);
setenv("bldstr", envstr);
saveenv();
}
if( getenv("fakeled")) {
- karef_ps = (KAREF_FPGA_REGS_ST *)CFG_KAREF_FPGA_BASE;
- ofem_ps = (OFEM_FPGA_REGS_ST *)CFG_OFEM_FPGA_BASE;
+ karef_ps = (KAREF_FPGA_REGS_ST *)CONFIG_SYS_KAREF_FPGA_BASE;
+ ofem_ps = (OFEM_FPGA_REGS_ST *)CONFIG_SYS_OFEM_FPGA_BASE;
ofem_ps->control_ul &= ~SAND_HAL_KA_SC_SCAN_CNTL_FAULT_LED_MASK;
karef_ps->control_ul &= ~SAND_HAL_KA_OF_OFEM_CNTL_FAULT_LED_MASK;
setenv("bootdelay", "-1");
printf("fakeled is set. use 'setenv fakeled ; setenv bootdelay 5 ; saveenv' to recover\n");
}
+#ifdef CONFIG_HAS_ETH0
+ if (!eth_getenv_enetaddr("ethaddr", enetaddr)) {
+ board_get_enetaddr(0, enetaddr);
+ eth_setenv_enetaddr("ethaddr", enetaddr);
+ }
+#endif
+
+#ifdef CONFIG_HAS_ETH1
+ if (!eth_getenv_enetaddr("eth1addr", enetaddr)) {
+ board_get_enetaddr(1, enetaddr);
+ eth_setenv_enetaddr("eth1addr", enetaddr);
+ }
+#endif
+
+#ifdef CONFIG_HAS_ETH2
+ if (!eth_getenv_enetaddr("eth2addr", enetaddr)) {
+ board_get_enetaddr(2, enetaddr);
+ eth_setenv_enetaddr("eth2addr", enetaddr);
+ }
+#endif
+
+#ifdef CONFIG_HAS_ETH3
+ if (!eth_getenv_enetaddr("eth3addr", enetaddr)) {
+ board_get_enetaddr(3, enetaddr);
+ eth_setenv_enetaddr("eth3addr", enetaddr);
+ }
+#endif
+
return (0);
}
{
KAREF_FPGA_REGS_ST *karef_ps;
/* TODO: ide reset */
- karef_ps = (KAREF_FPGA_REGS_ST *)CFG_KAREF_FPGA_BASE;
+ karef_ps = (KAREF_FPGA_REGS_ST *)CONFIG_SYS_KAREF_FPGA_BASE;
if (on) {
karef_ps->reset_ul &= ~SAND_HAL_KA_SC_SCAN_RESET_CF_RESET_N_MASK;
/* Ensure we have power all around */
udelay(500);
- karef_ps = (KAREF_FPGA_REGS_ST *)CFG_KAREF_FPGA_BASE;
+ karef_ps = (KAREF_FPGA_REGS_ST *)CONFIG_SYS_KAREF_FPGA_BASE;
tmp =
SAND_HAL_KA_SC_SCAN_RESET_CF_RESET_N_MASK |
SAND_HAL_KA_SC_SCAN_RESET_BME_RESET_N_MASK |
SAND_HAL_KA_OF_OFEM_RESET_LOCH0_RESET_N_MASK |
SAND_HAL_KA_OF_OFEM_RESET_MAC0_RESET_N_MASK;
- ofem_ps = (OFEM_FPGA_REGS_ST *)CFG_OFEM_FPGA_BASE;
+ ofem_ps = (OFEM_FPGA_REGS_ST *)CONFIG_SYS_OFEM_FPGA_BASE;
ofem_ps->reset_ul = tmp;
ofem_ps->control_ul |= 1 < SAND_HAL_KA_OF_OFEM_CNTL_FAULT_LED_SHIFT;
}
U_BOOT_CMD(kasetup, 1, 1, karefSetupVars,
- "kasetup - Set environment to factory defaults\n", NULL);
+ "Set environment to factory defaults", "");
U_BOOT_CMD(karecover, 1, 1, karefRecover,
- "karecover - Set environment to allow for fs recovery\n", NULL);
+ "Set environment to allow for fs recovery", "");
projects / karo-tx-uboot.git / blobdiff