#include <common.h>
#include <mpc5xxx.h>
#include <pci.h>
+#include <netdev.h>
#include "sdram.h"
#include "mt48lc16m16a2-75.h"
#endif
-long int initdram (int board_type)
+phys_size_t initdram (int board_type)
{
sdram_conf_t sdram_conf;
puts ("Board: Total5100 ");
#endif
-/*
- * Retrieve FPGA Revision.
- */
-printf ("(FPGA %08X)\n", *(vu_long *) (CFG_FPGA_BASE + 0x400));
+ /*
+ * Retrieve FPGA Revision.
+ */
+ printf ("(FPGA %08lX)\n", *(vu_long *) (CONFIG_SYS_FPGA_BASE + 0x400));
-/*
- * Take all peripherals in power-up mode.
- */
+ /*
+ * Take all peripherals in power-up mode.
+ */
#if CONFIG_TOTAL5200_REV==2
- *(vu_char *) (CFG_CPLD_BASE + 0x46) = 0x70;
+ *(vu_char *) (CONFIG_SYS_CPLD_BASE + 0x46) = 0x70;
#else
- *(vu_long *) (CFG_CPLD_BASE + 0x400) = 0x70;
+ *(vu_long *) (CONFIG_SYS_CPLD_BASE + 0x400) = 0x70;
#endif
return 0;
}
#endif
-#if defined (CFG_CMD_IDE) && defined (CONFIG_IDE_RESET)
+#if defined(CONFIG_CMD_IDE) && defined(CONFIG_IDE_RESET)
/* IRDA_1 aka PSC6_3 (pin C13) */
#define GPIO_IRDA_1 0x20000000UL
{
debug ("init_ide_reset\n");
- /* Configure IRDA_1 (PSC6_3) as GPIO output for ATA reset */
+ /* Configure IRDA_1 (PSC6_3) as GPIO output for ATA reset */
*(vu_long *) MPC5XXX_GPIO_ENABLE |= GPIO_IRDA_1;
*(vu_long *) MPC5XXX_GPIO_DIR |= GPIO_IRDA_1;
}
*(vu_long *) MPC5XXX_GPIO_DATA_O |= GPIO_IRDA_1;
}
}
-#endif /* defined (CFG_CMD_IDE) && defined (CONFIG_IDE_RESET) */
+#endif
#ifdef CONFIG_VIDEO_SED13806
#include <sed13806.h>
/* Returns SED13806 base address. First thing called in the driver. */
unsigned int board_video_init (void)
{
- return CFG_LCD_BASE;
+ return CONFIG_SYS_LCD_BASE;
}
/* Called after initializing the SED13806 and before clearing the screen. */
}
#endif /* CONFIG_VIDEO_SED13806 */
+
+int board_eth_init(bd_t *bis)
+{
+ cpu_eth_init(bis); /* Built in FEC comes first */
+ return pci_eth_init(bis);
+}