mx28evk: Move README file inside board directory

[karo-tx-uboot.git] / doc / README.mx28evk

diff --git a/doc/README.mx28evk b/doc/README.mx28evk
deleted file mode 100644 (file)
index 524f3fc..0000000
--- a/doc/README.mx28evk
+++ /dev/null
@@ -1,46 +0,0 @@
-FREESCALE MX28EVK
-==================
-
-Supported hardware: only MX28EVK rev D is supported in U-boot.
-
-Files of the MX28EVK port
---------------------------
-
-arch/arm/cpu/arm926ejs/mxs/    - The CPU support code for the Freescale i.MX28
-arch/arm/include/asm/arch-mxs/ - Header files for the Freescale i.MX28
-board/freescale/mx28evk/       - MX28EVK board specific files
-include/configs/mx28evk.h      - MX28EVK configuration file
-
-Jumper configuration
----------------------
-
-To boot MX28EVK from an SD card, set the boot mode DIP switches as:
-
-   * Boot Mode Select: 1 0 0 1 (Boot from SD card Slot 0 - U42)
-   * JTAG PSWITCH RESET: To the right (reset disabled)
-   * Battery Source: Down
-   * Wall 5V: Up
-   * VDD 5V: To the left (off)
-   * Hold Button: Down (off)
-
-
-Environment Storage
--------------------
-
-There are two targets for mx28evk:
-
-"make mx28evk_config"          - store enviroment variables into MMC
-
-or
-
-"make mx28evk_nand_config"     - store enviroment variables into NAND flash
-
-Choose the target accordingly.
-
-Note: The mx28evk board does not come with a NAND flash populated from the
-factory. It comes with an empty slot (U23), which allows the insertion of a
-48-pin TSOP flash device.
-
-Follow the instructions from doc/README.mxs to generate a bootable SD card.
-
-Insert the SD card in slot 0, power up the board and U-boot will boot.