Remove unused CONFIG_SERIAL_SOFTWARE_FIFO feature

[karo-tx-uboot.git] / include / configs / P1_P2_RDB.h

diff --git a/include/configs/P1_P2_RDB.h b/include/configs/P1_P2_RDB.h
index e2930c19b3087679d560f375950a8d2951192418..fa45b5be17c135e135bd1df669c2621db3dfc9e5 100644 (file)
--- a/include/configs/P1_P2_RDB.h
+++ b/include/configs/P1_P2_RDB.h
@@ -74,6 +74,7 @@
 #define CONFIG_TSEC_ENET               /* tsec ethernet support */
 #define CONFIG_ENV_OVERWRITE
 
+#define CONFIG_E1000           1       /*  E1000 pci Ethernet card*/
 #ifndef __ASSEMBLY__
 extern unsigned long get_board_sys_clk(unsigned long dummy);
 #endif
@@ -84,6 +85,8 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_MP
 #endif
 
+#define CONFIG_HWCONFIG
+
 /*
  * These can be toggled for performance analysis, otherwise use default.
  */
@@ -126,9 +129,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_CCSRBAR_DEFAULT     0xff700000      /* CCSRBAR Default */
 #endif
 
-#define CONFIG_SYS_PCIE2_ADDR          (CONFIG_SYS_CCSRBAR+0x9000)
-#define CONFIG_SYS_PCIE1_ADDR          (CONFIG_SYS_CCSRBAR+0xa000)
-
 /* DDR Setup */
 #define CONFIG_FSL_DDR2
 #undef CONFIG_FSL_DDR_INTERACTIVE
@@ -149,8 +149,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_DDR_ERR_DIS         0x00000000
 #define CONFIG_SYS_DDR_SBE             0x00FF0000
 
-#define CONFIG_SYS_DDR_TLB_START 9
-
 /*
  * Memory map
  *
@@ -205,6 +203,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_FLASH_AMD_CHECK_DQ7
 
 #define CONFIG_BOARD_EARLY_INIT_R      /* call board_early_init_r function */
+#define CONFIG_HWCONFIG
 
 #define CONFIG_SYS_INIT_RAM_LOCK       1
 #define CONFIG_SYS_INIT_RAM_ADDR      0xffd00000       /* stack in RAM */
@@ -282,11 +281,13 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
  * shorted - index 1
  */
 #define CONFIG_CONS_INDEX      1
-#undef CONFIG_SERIAL_SOFTWARE_FIFO
 #define CONFIG_SYS_NS16550
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK         get_bus_freq(0)
+#ifdef CONFIG_NAND_SPL
+#define CONFIG_NS16550_MIN_FUNCTIONS
+#endif
 
 #define CONFIG_SERIAL_MULTI    1 /* Enable both serial ports */
 #define CONFIG_SYS_CONSOLE_IS_IN_ENV   /* determine from environment */
@@ -310,9 +311,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_OF_BOARD_SETUP          1
 #define CONFIG_OF_STDOUT_VIA_ALIAS     1
 
-#define CONFIG_SYS_64BIT_VSPRINTF      1
-#define CONFIG_SYS_64BIT_STRTOUL       1
-
 /* new uImage format support */
 #define CONFIG_FIT             1
 #define CONFIG_FIT_VERBOSE     1 /* enable fit_format_{error,warning}() */
@@ -426,6 +424,15 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_ETHPRIME                "eTSEC1"
 
 #define CONFIG_PHY_GIGE                1       /* Include GbE speed/duplex detection */
+
+/* TBI PHY configuration for SGMII mode */
+#define CONFIG_TSEC_TBICR_SETTINGS ( \
+               TBICR_PHY_RESET \
+               | TBICR_ANEG_ENABLE \
+               | TBICR_FULL_DUPLEX \
+               | TBICR_SPEED1_SET \
+               )
+
 #endif /* CONFIG_TSEC_ENET */
 
 /*
@@ -467,6 +474,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_PING
 #define CONFIG_CMD_SETEXPR
+#define CONFIG_CMD_REGINFO
 
 #if defined(CONFIG_PCI)
 #define CONFIG_CMD_NET
@@ -509,6 +517,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
  */
 #define CONFIG_SYS_LONGHELP                    /* undef to save memory */
 #define CONFIG_CMDLINE_EDITING                 /* Command-line editing */
+#define CONFIG_AUTO_COMPLETE                   /* add autocompletion support */
 #define CONFIG_SYS_LOAD_ADDR   0x2000000       /* default load address */
 #define CONFIG_SYS_PROMPT      "=> "           /* Monitor Command Prompt */
 #if defined(CONFIG_CMD_KGDB)
@@ -569,7 +578,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
        "netdev=eth0\0"                                         \
        "uboot=" MK_STR(CONFIG_UBOOTPATH) "\0"                          \
        "loadaddr=1000000\0"                    \
-       "bootfile=uImage\0"     \
        "tftpflash=tftpboot $loadaddr $uboot; "                 \
                "protect off " MK_STR(TEXT_BASE) " +$filesize; "        \
                "erase " MK_STR(TEXT_BASE) " +$filesize; "              \