Merge branch 'u-boot-samsung/master' into 'u-boot-arm/master'

[karo-tx-uboot.git] / include / mmc.h

diff --git a/include/mmc.h b/include/mmc.h
index 21d0937d5c92b6b57020636db0057371906314f2..f88f672f111fee172e655167b0284e5b7521774d 100644 (file)
--- a/include/mmc.h
+++ b/include/mmc.h
@@ -68,6 +68,7 @@
 #define UNUSABLE_ERR           -17 /* Unusable Card */
 #define COMM_ERR               -18 /* Communications Error */
 #define TIMEOUT                        -19
+#define IN_PROGRESS            -20 /* operation is in progress */
 
 #define MMC_CMD_GO_IDLE_STATE          0
 #define MMC_CMD_SEND_OP_COND           1
@@ -291,6 +292,10 @@ struct mmc {
        int (*getcd)(struct mmc *mmc);
        int (*getwp)(struct mmc *mmc);
        uint b_max;
+       char op_cond_pending;   /* 1 if we are waiting on an op_cond command */
+       char init_in_progress;  /* 1 if we have done mmc_start_init() */
+       char preinit;           /* start init as early as possible */
+       uint op_cond_response;  /* the response byte from the last op_cond */
 };
 
 int mmc_register(struct mmc *mmc);
@@ -313,6 +318,31 @@ int mmc_boot_partition_size_change(struct mmc *mmc, unsigned long bootsize,
 /* Function to send commands to open/close the specified boot partition */
 int mmc_boot_part_access(struct mmc *mmc, u8 ack, u8 part_num, u8 access);
 
+/**
+ * Start device initialization and return immediately; it does not block on
+ * polling OCR (operation condition register) status.  Then you should call
+ * mmc_init, which would block on polling OCR status and complete the device
+ * initializatin.
+ *
+ * @param mmc  Pointer to a MMC device struct
+ * @return 0 on success, IN_PROGRESS on waiting for OCR status, <0 on error.
+ */
+int mmc_start_init(struct mmc *mmc);
+
+/**
+ * Set preinit flag of mmc device.
+ *
+ * This will cause the device to be pre-inited during mmc_initialize(),
+ * which may save boot time if the device is not accessed until later.
+ * Some eMMC devices take 200-300ms to init, but unfortunately they
+ * must be sent a series of commands to even get them to start preparing
+ * for operation.
+ *
+ * @param mmc          Pointer to a MMC device struct
+ * @param preinit      preinit flag value
+ */
+void mmc_set_preinit(struct mmc *mmc, int preinit);
+
 #ifdef CONFIG_GENERIC_MMC
 #define mmc_host_is_spi(mmc)   ((mmc)->host_caps & MMC_MODE_SPI)
 struct mmc *mmc_spi_init(uint bus, uint cs, uint speed, uint mode);