X-Git-Url: https://git.kernelconcepts.de/?p=karo-tx-uboot.git;a=blobdiff_plain;f=include%2Fconfigs%2Ftx6.h;h=dcd36decc742631644e5d3583652b0b77a92e103;hp=8b1b05be803d1dd3e4c138c78bb444fee0ff90b8;hb=13a3e2ee237f515af5738c07aaf604db9b54be34;hpb=ff78a3e22349a3d692d7c849abf9816af1627681;ds=sidebyside

diff --git a/include/configs/tx6.h b/include/configs/tx6.h
index 8b1b05be80..dcd36decc7 100644
--- a/include/configs/tx6.h
+++ b/include/configs/tx6.h
@@ -317,22 +317,21 @@
 #error Unsupported TX6 module revision
 #endif
 #else /* CONFIG_TX6_REV */
-/* autodetect which PMIC is present to derive TX6_REV */
 #ifdef CONFIG_SOC_MX6UL
-#ifndef CONFIG_TX6_UBOOT_NOENV
+#ifdef CONFIG_SYS_I2C_SOFT
 /* NOENV U-Boot is used for initial bootstrap.
  * Since the TAMPER_PIN_DISABLE fuses have to be programmed
  * to be able to use the TAMPER pins as GPIO to access the
  * PMIC I2C bus, this is not possible on virgin hardware.
  */
-#define CONFIG_SYS_I2C
-#define CONFIG_SYS_I2C_SOFT
 #define CONFIG_SYS_I2C_SOFT_SPEED	400000
+#define CONFIG_SYS_I2C_SPEED		CONFIG_SYS_I2C_SOFT_SPEED
 #define CONFIG_SOFT_I2C_GPIO_SCL	IMX_GPIO_NR(5, 0)
 #define CONFIG_SOFT_I2C_GPIO_SDA	IMX_GPIO_NR(5, 1)
 #define CONFIG_SOFT_I2C_READ_REPEATED_START
-#endif /* CONFIG_TX6_UBOOT_NOENV */
+#endif /* CONFIG_SYS_I2C_SOFT */
 #else /* !CONFIG_SOC_MX6UL */
+/* autodetect which PMIC is present to derive TX6_REV */
 #define CONFIG_LTC3676			/* TX6_REV == 1 */
 #endif /*  CONFIG_SOC_MX6UL */
 #define CONFIG_RN5T567			/* TX6_REV == 3 */