Documentation/devicetree/bindings/regulator/max8973-regulator.txt

   1 * Maxim MAX8973 Voltage Regulator
   2
   3 Required properties:
   4
   5 - compatible:   must be one of following:
   6                         "maxim,max8973"
   7                         "maxim,max77621".
   8 - reg:          the i2c slave address of the regulator. It should be 0x1b.
   9
  10 Any standard regulator properties can be used to configure the single max8973
  11 DCDC.
  12
  13 Optional properties:
  14
  15 -maxim,externally-enable: boolean, externally control the regulator output
  16                 enable/disable.
  17 -maxim,enable-gpio: GPIO for enable control. If the valid GPIO is provided
  18                 then externally enable control will be considered.
  19 -maxim,dvs-gpio: GPIO which is connected to DVS pin of device.
  20 -maxim,dvs-default-state: Default state of GPIO during initialisation.
  21                 1 for HIGH and 0 for LOW.
  22 -maxim,enable-remote-sense: boolean, enable reote sense.
  23 -maxim,enable-falling-slew-rate: boolean, enable falling slew rate.
  24 -maxim,enable-active-discharge: boolean: enable active discharge.
  25 -maxim,enable-frequency-shift: boolean, enable 9% frequency shift.
  26 -maxim,enable-bias-control: boolean, enable bias control. By enabling this
  27                 startup delay can be reduce to 20us from 220us.
  28 -maxim,enable-etr: boolean, enable Enhanced Transient Response.
  29 -maxim,enable-high-etr-sensitivity: boolean, Enhanced transient response
  30                 circuit is enabled and set for high sensitivity. If this
  31                 property is available then etr will be enable default.
  32
  33 Enhanced transient response (ETR) will affect the configuration of CKADV.
  34
  35 Example:
  36
  37         max8973@1b {
  38                 compatible = "maxim,max8973";
  39                 reg = <0x1b>;
  40
  41                 regulator-min-microvolt = <935000>;
  42                 regulator-max-microvolt = <1200000>;
  43                 regulator-boot-on;
  44                 regulator-always-on;
  45         };