]> git.kernelconcepts.de Git - karo-tx-uboot.git/blob - include/configs/davinci_dm365evm.h
karo: tx6: enable GPT command
[karo-tx-uboot.git] / include / configs / davinci_dm365evm.h
1 /*
2  * Copyright (C) 2009 Texas Instruments Incorporated
3  *
4  * SPDX-License-Identifier:     GPL-2.0+
5  */
6
7 #ifndef __CONFIG_H
8 #define __CONFIG_H
9
10 /* Spectrum Digital TMS320DM365 EVM board */
11 #define DAVINCI_DM365EVM
12
13 #define CONFIG_SKIP_LOWLEVEL_INIT       /* U-Boot is a 3rd stage loader */
14 #define CONFIG_SYS_NO_FLASH             /* that is, no *NOR* flash */
15 #define CONFIG_SYS_CONSOLE_INFO_QUIET
16
17 /* SoC Configuration */
18 #define CONFIG_SYS_TIMERBASE            0x01c21400      /* use timer 0 */
19 #define CONFIG_SYS_HZ_CLOCK             24000000        /* timer0 freq */
20 #define CONFIG_SOC_DM365
21
22 /* Memory Info */
23 #define CONFIG_NR_DRAM_BANKS            1
24 #define PHYS_SDRAM_1                    0x80000000
25 #define PHYS_SDRAM_1_SIZE               (128 << 20)     /* 128 MiB */
26
27 /* Serial Driver info: UART0 for console  */
28 #define CONFIG_SYS_NS16550
29 #define CONFIG_SYS_NS16550_SERIAL
30 #define CONFIG_SYS_NS16550_REG_SIZE     -4
31 #define CONFIG_SYS_NS16550_COM1         0x01c20000
32 #define CONFIG_SYS_NS16550_CLK          CONFIG_SYS_HZ_CLOCK
33 #define CONFIG_CONS_INDEX               1
34 #define CONFIG_BAUDRATE                 115200
35
36 /* EEPROM definitions for EEPROM on DM365 EVM */
37 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN          2
38 #define CONFIG_SYS_I2C_EEPROM_ADDR              0x50
39 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS       6
40 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS   20
41
42 /* Network Configuration */
43 #define CONFIG_DRIVER_TI_EMAC
44 #define CONFIG_MII
45 #define CONFIG_BOOTP_DNS
46 #define CONFIG_BOOTP_DNS2
47 #define CONFIG_BOOTP_SEND_HOSTNAME
48 #define CONFIG_NET_RETRY_COUNT  10
49
50 /* I2C */
51 #define CONFIG_SYS_I2C
52 #define CONFIG_SYS_I2C_DAVINCI
53 #define CONFIG_SYS_DAVINCI_I2C_SPEED            400000
54 #define CONFIG_SYS_DAVINCI_I2C_SLAVE            0x10    /* SMBus host address */
55
56 /* NAND: socketed, two chipselects, normally 2 GBytes */
57 #define CONFIG_NAND_DAVINCI
58 #define CONFIG_SYS_NAND_CS              2
59 #define CONFIG_SYS_NAND_USE_FLASH_BBT
60 #define CONFIG_SYS_NAND_4BIT_HW_ECC_OOBFIRST
61 #define CONFIG_SYS_NAND_PAGE_2K
62
63 #define CONFIG_SYS_NAND_LARGEPAGE
64 #define CONFIG_SYS_NAND_BASE_LIST       { 0x02000000, }
65 /* socket has two chipselects, nCE0 gated by address BIT(14) */
66 #define CONFIG_SYS_MAX_NAND_DEVICE      1
67 #define CONFIG_SYS_NAND_MAX_CHIPS       2
68
69 /* SD/MMC */
70 #define CONFIG_MMC
71 #define CONFIG_GENERIC_MMC
72 #define CONFIG_DAVINCI_MMC
73 #define CONFIG_DAVINCI_MMC_SD1
74 #define CONFIG_MMC_MBLOCK
75
76 #define PINMUX4_USBDRVBUS_BITCLEAR       0x3000
77 #define PINMUX4_USBDRVBUS_BITSET         0x2000
78
79 /* USB Configuration */
80 #define CONFIG_USB_DAVINCI
81 #define CONFIG_USB_MUSB_HCD
82
83 #ifdef CONFIG_USB_DAVINCI
84 #define CONFIG_CMD_USB         /* include support for usb      */
85 #define CONFIG_CMD_STORAGE     /* include support for usb      */
86 #define CONFIG_CMD_FAT         /* include support for FAT/storage*/
87 #define CONFIG_DOS_PARTITION   /* include support for FAT/storage*/
88 #endif
89
90 #ifdef CONFIG_USB_MUSB_HCD         /* include support for usb host */
91 #define CONFIG_CMD_USB         /* include support for usb cmd */
92 #define CONFIG_USB_STORAGE     /* MSC class support */
93 #define CONFIG_CMD_STORAGE     /* inclue support for usb-storage cmd */
94 #define CONFIG_CMD_FAT         /* inclue support for FAT/storage */
95 #define CONFIG_DOS_PARTITION   /* inclue support for FAT/storage */
96
97 #ifdef CONFIG_USB_KEYBOARD     /* HID class support */
98 #define CONFIG_SYS_USB_EVENT_POLL
99
100 #define CONFIG_PREBOOT "usb start"
101 #endif /* CONFIG_USB_KEYBOARD */
102 #endif /* CONFIG_USB_MUSB_HCD */
103
104 #ifdef CONFIG_USB_MUSB_UDC
105 #define CONFIG_USB_DEVICE              1
106 #define CONFIG_USB_TTY                 1
107 #define CONFIG_SYS_CONSOLE_IS_IN_ENV   1
108 #define CONFIG_USBD_VENDORID           0x0451
109 #define CONFIG_USBD_PRODUCTID          0x5678
110 #define CONFIG_USBD_MANUFACTURER       "Texas Instruments"
111 #define CONFIG_USBD_PRODUCT_NAME       "DM365VM"
112 #endif /* CONFIG_USB_MUSB_UDC */
113
114 /* U-Boot command configuration */
115 #define CONFIG_CMD_ASKENV
116 #define CONFIG_CMD_DHCP
117 #define CONFIG_CMD_I2C
118 #define CONFIG_CMD_PING
119 #define CONFIG_CMD_SAVES
120
121 #ifdef CONFIG_CMD_BDI
122 #define CONFIG_CLOCKS
123 #endif
124
125 #ifdef CONFIG_MMC
126 #define CONFIG_DOS_PARTITION
127 #define CONFIG_CMD_EXT2
128 #define CONFIG_CMD_FAT
129 #define CONFIG_CMD_MMC
130 #endif
131
132 #ifdef CONFIG_NAND_DAVINCI
133 #define CONFIG_CMD_MTDPARTS
134 #define CONFIG_MTD_PARTITIONS
135 #define CONFIG_MTD_DEVICE
136 #define CONFIG_CMD_NAND
137 #define CONFIG_CMD_UBI
138 #define CONFIG_RBTREE
139 #endif
140
141 #define CONFIG_CRC32_VERIFY
142 #define CONFIG_MX_CYCLIC
143
144 /* U-Boot general configuration */
145 #define CONFIG_BOOTFILE         "uImage"        /* Boot file name */
146 #define CONFIG_SYS_CBSIZE       1024            /* Console I/O Buffer Size  */
147 #define CONFIG_SYS_PBSIZE                       /* Print buffer size */ \
148                 (CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)
149 #define CONFIG_SYS_MAXARGS      16              /* max number of command args */
150 #define CONFIG_SYS_HUSH_PARSER
151 #define CONFIG_SYS_LONGHELP
152
153 #ifdef CONFIG_NAND_DAVINCI
154 #define CONFIG_ENV_SIZE         (256 << 10)     /* 256 KiB */
155 #define CONFIG_ENV_IS_IN_NAND
156 #define CONFIG_ENV_OFFSET       0x3C0000
157 #undef CONFIG_ENV_IS_IN_FLASH
158 #endif
159
160 #if defined(CONFIG_MMC) && !defined(CONFIG_ENV_IS_IN_NAND)
161 #define CONFIG_CMD_ENV
162 #define CONFIG_ENV_SIZE         (16 << 10)      /* 16 KiB */
163 #define CONFIG_ENV_OFFSET       (51 << 9)       /* Sector 51 */
164 #define CONFIG_ENV_IS_IN_MMC
165 #undef CONFIG_ENV_IS_IN_FLASH
166 #endif
167
168 #define CONFIG_BOOTDELAY        3
169 #define CONFIG_BOOTCOMMAND \
170                 "dhcp;bootm"
171 #define CONFIG_BOOTARGS \
172                 "console=ttyS0,115200n8 " \
173                 "root=/dev/mmcblk0p1 rootwait rootfstype=ext3 ro"
174
175 #define CONFIG_CMDLINE_EDITING
176 #define CONFIG_VERSION_VARIABLE
177 #define CONFIG_TIMESTAMP
178
179 /* U-Boot memory configuration */
180 #define CONFIG_SYS_MALLOC_LEN           (1 << 20)       /* 1 MiB */
181 #define CONFIG_SYS_MEMTEST_START        0x87000000      /* physical address */
182 #define CONFIG_SYS_MEMTEST_END          0x88000000      /* test 16MB RAM */
183
184 /* Linux interfacing */
185 #define CONFIG_CMDLINE_TAG
186 #define CONFIG_SETUP_MEMORY_TAGS
187 #define CONFIG_SYS_BARGSIZE     1024                    /* bootarg Size */
188 #define CONFIG_SYS_LOAD_ADDR    0x80700000              /* kernel address */
189
190
191 /* NAND configuration issocketed with two chipselects just like the DM355 EVM.
192  * It normally comes with a 2GByte SLC part with 2KB pages
193  * (and 128KB erase blocks); other
194  * 2GByte parts may have 4KB pages, 256KB erase blocks, and use MLC.  (MLC
195  * pretty much demands the 4-bit ECC support.)  You can of course swap in
196  * other parts, including small page ones.
197  */
198 #define MTDIDS_DEFAULT          "nand0=davinci_nand.0"
199
200 #ifdef CONFIG_SYS_NAND_LARGEPAGE
201 /*  Use same layout for 128K/256K blocks; allow some bad blocks */
202 #define PART_BOOT               "2m(bootloader)ro,"
203 #else
204 /* Assume 16K erase blocks; allow a few bad ones. */
205 #define PART_BOOT               "512k(bootloader)ro,"
206 #endif
207
208 #define PART_KERNEL             "4m(kernel),"   /* kernel + initramfs */
209 #define PART_REST               "-(filesystem)"
210
211 #define MTDPARTS_DEFAULT        \
212         "mtdparts=davinci_nand.0:" PART_BOOT PART_KERNEL PART_REST
213
214 #define CONFIG_MAX_RAM_BANK_SIZE        (256 << 20)     /* 256 MB */
215
216 #define CONFIG_SYS_SDRAM_BASE           PHYS_SDRAM_1
217 #define CONFIG_SYS_INIT_SP_ADDR         \
218         (CONFIG_SYS_SDRAM_BASE + 0x1000 - GENERATED_GBL_DATA_SIZE)
219
220 #endif /* __CONFIG_H */