dm: exynos: dts: Adjust device tree files for U-Boot

[karo-tx-uboot.git] / README

diff --git a/README b/README
index 517b0b4499da94b515de347a70d808ad22f7a178..19abe20035394d07d1191b434f89124ecee8f6ea 100644 (file)
--- a/README
+++ b/README
@@ -272,7 +272,7 @@ board. This allows feature development which is not board- or architecture-
 specific to be undertaken on a native platform. The sandbox is also used to
 run some of U-Boot's tests.
 
-See board/sandbox/sandbox/README.sandbox for more details.
+See board/sandbox/README.sandbox for more details.
 
 
 Configuration Options:
@@ -538,6 +538,18 @@ The following options need to be configured:
                interleaving mode, handled by Dickens for Freescale layerscape
                SoCs with ARM core.
 
+               CONFIG_SYS_FSL_DDR_MAIN_NUM_CTRLS
+               Number of controllers used as main memory.
+
+               CONFIG_SYS_FSL_OTHER_DDR_NUM_CTRLS
+               Number of controllers used for other than main memory.
+
+               CONFIG_SYS_FSL_SEC_BE
+               Defines the SEC controller register space as Big Endian
+
+               CONFIG_SYS_FSL_SEC_LE
+               Defines the SEC controller register space as Little Endian
+
 - Intel Monahans options:
                CONFIG_SYS_MONAHANS_RUN_MODE_OSC_RATIO
 
@@ -959,6 +971,7 @@ The following options need to be configured:
                CONFIG_CMD_BMP          * BMP support
                CONFIG_CMD_BSP          * Board specific commands
                CONFIG_CMD_BOOTD          bootd
+               CONFIG_CMD_BOOTI        * ARM64 Linux kernel Image support
                CONFIG_CMD_CACHE        * icache, dcache
                CONFIG_CMD_CLK          * clock command support
                CONFIG_CMD_CONSOLE        coninfo
@@ -1628,6 +1641,16 @@ The following options need to be configured:
                downloads. This buffer should be as large as possible for a
                platform. Define this to the size available RAM for fastboot.
 
+               CONFIG_FASTBOOT_FLASH
+               The fastboot protocol includes a "flash" command for writing
+               the downloaded image to a non-volatile storage device. Define
+               this to enable the "fastboot flash" command.
+
+               CONFIG_FASTBOOT_FLASH_MMC_DEV
+               The fastboot "flash" command requires additional information
+               regarding the non-volatile storage device. Define this to
+               the eMMC device that fastboot should use to store the image.
+
 - Journaling Flash filesystem support:
                CONFIG_JFFS2_NAND, CONFIG_JFFS2_NAND_OFF, CONFIG_JFFS2_NAND_SIZE,
                CONFIG_JFFS2_NAND_DEV
@@ -3848,12 +3871,9 @@ Configuration Settings:
                The memory will be freed (or in fact just forgotton) when
                U-Boot relocates itself.
 
-               Pre-relocation malloc() is only supported on sandbox
+               Pre-relocation malloc() is only supported on ARM and sandbox
                at present but is fairly easy to enable for other archs.
 
-               Pre-relocation malloc() is only supported on ARM at present
-               but is fairly easy to enable for other archs.
-
 - CONFIG_SYS_BOOTM_LEN:
                Normally compressed uImages are limited to an
                uncompressed size of 8 MBytes. If this is not enough,