Merge branch 'master' of git://git.denx.de/u-boot-mmc

[karo-tx-uboot.git] / README

diff --git a/README b/README
index 0bd4069da63a16b01b07e68ca9eed4ed5346c323..a280435e9fbec65012cf9758a66f6827d2f22353 100644 (file)
--- a/README
+++ b/README
@@ -1589,6 +1589,28 @@ The following options need to be configured:
                entering dfuMANIFEST state. Host waits this timeout, before
                sending again an USB request to the device.
 
+- USB Device Android Fastboot support:
+               CONFIG_CMD_FASTBOOT
+               This enables the command "fastboot" which enables the Android
+               fastboot mode for the platform's USB device. Fastboot is a USB
+               protocol for downloading images, flashing and device control
+               used on Android devices.
+               See doc/README.android-fastboot for more information.
+
+               CONFIG_ANDROID_BOOT_IMAGE
+               This enables support for booting images which use the Android
+               image format header.
+
+               CONFIG_USB_FASTBOOT_BUF_ADDR
+               The fastboot protocol requires a large memory buffer for
+               downloads. Define this to the starting RAM address to use for
+               downloaded images.
+
+               CONFIG_USB_FASTBOOT_BUF_SIZE
+               The fastboot protocol requires a large memory buffer for
+               downloads. This buffer should be as large as possible for a
+               platform. Define this to the size available RAM for fastboot.
+
 - Journaling Flash filesystem support:
                CONFIG_JFFS2_NAND, CONFIG_JFFS2_NAND_OFF, CONFIG_JFFS2_NAND_SIZE,
                CONFIG_JFFS2_NAND_DEV
@@ -2560,6 +2582,19 @@ CBFS (Coreboot Filesystem) support
 
                Specify the number of FPGA devices to support.
 
+               CONFIG_CMD_FPGA_LOADMK
+
+               Enable support for fpga loadmk command
+
+               CONFIG_CMD_FPGA_LOADP
+
+               Enable support for fpga loadp command - load partial bitstream
+
+               CONFIG_CMD_FPGA_LOADBP
+
+               Enable support for fpga loadbp command - load partial bitstream
+               (Xilinx only)
+
                CONFIG_SYS_FPGA_PROG_FEEDBACK
 
                Enable printing of hash marks during FPGA configuration.