snapper9260: remove unused AT91_LEGACY

[karo-tx-uboot.git] / README

diff --git a/README b/README
index b0c2fdc73de47c1ef774093caea4f6b156703af2..f0ffaf491cd9c204b24a49aacf4d9712148cdf32 100644 (file)
--- a/README
+++ b/README
@@ -784,6 +784,22 @@ The following options need to be configured:
                as a convenience, when switching between booting from
                RAM and NFS.
 
+- Bootcount:
+               CONFIG_BOOTCOUNT_LIMIT
+               Implements a mechanism for detecting a repeating reboot
+               cycle, see:
+               http://www.denx.de/wiki/view/DULG/UBootBootCountLimit
+
+               CONFIG_BOOTCOUNT_ENV
+               If no softreset save registers are found on the hardware
+               "bootcount" is stored in the environment. To prevent a
+               saveenv on all reboots, the environment variable
+               "upgrade_available" is used. If "upgrade_available" is
+               0, "bootcount" is always 0, if "upgrade_available" is
+               1 "bootcount" is incremented in the environment.
+               So the Userspace Applikation must set the "upgrade_available"
+               and "bootcount" variable to 0, if a boot was successfully.
+
 - Pre-Boot Commands:
                CONFIG_PREBOOT
 
@@ -848,6 +864,7 @@ The following options need to be configured:
                CONFIG_CMD_ELF          * bootelf, bootvx
                CONFIG_CMD_ENV_CALLBACK * display details about env callbacks
                CONFIG_CMD_ENV_FLAGS    * display details about env flags
+               CONFIG_CMD_ENV_EXISTS   * check existence of env variable
                CONFIG_CMD_EXPORTENV    * export the environment
                CONFIG_CMD_EXT2         * ext2 command support
                CONFIG_CMD_EXT4         * ext4 command support
@@ -1032,7 +1049,6 @@ The following options need to be configured:
 
 - GPIO Support:
                CONFIG_PCA953X          - use NXP's PCA953X series I2C GPIO
-               CONFIG_PCA953X_INFO     - enable pca953x info command
 
                The CONFIG_SYS_I2C_PCA953X_WIDTH option specifies a list of
                chip-ngpio pairs that tell the PCA953X driver the number of
@@ -4303,6 +4319,9 @@ Low Level (hardware related) configuration options:
 
                NOTE : currently only supported on AM335x platforms.
 
+- CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC:
+               Enables the RTC32K OSC on AM33xx based plattforms
+
 Freescale QE/FMAN Firmware Support:
 -----------------------------------