#include <div64.h>
#include "mmc_private.h"
-/* Set block count limit because of 16 bit register limit on some hardware*/
-#ifndef CONFIG_SYS_MMC_MAX_BLK_COUNT
-#define CONFIG_SYS_MMC_MAX_BLK_COUNT 65535
-#endif
-
static struct list_head mmc_devices;
static int cur_dev_num = -1;
wp = board_mmc_getwp(mmc);
if (wp < 0) {
- if (mmc->ops->getwp)
- wp = mmc->ops->getwp(mmc);
+ if (mmc->cfg->ops->getwp)
+ wp = mmc->cfg->ops->getwp(mmc);
else
wp = 0;
}
printf("CMD_SEND:%d\n", cmd->cmdidx);
printf("\t\tARG\t\t\t 0x%08X\n", cmd->cmdarg);
- ret = mmc->ops->send_cmd(mmc, cmd, data);
+ ret = mmc->cfg->ops->send_cmd(mmc, cmd, data);
switch (cmd->resp_type) {
case MMC_RSP_NONE:
printf("\t\tMMC_RSP_NONE\n");
break;
}
#else
- ret = mmc->ops->send_cmd(mmc, cmd, data);
+ ret = mmc->cfg->ops->send_cmd(mmc, cmd, data);
#endif
return ret;
}
#endif
return TIMEOUT;
}
+ if (cmd.response[0] & MMC_STATUS_SWITCH_ERROR)
+ return SWITCH_ERR;
return 0;
}
{
struct mmc_cmd cmd;
+ if (mmc->card_caps & MMC_MODE_DDR_52MHz)
+ return 0;
+
cmd.cmdidx = MMC_CMD_SET_BLOCKLEN;
cmd.resp_type = MMC_RSP_R1;
cmd.cmdarg = len;
return 0;
do {
- cur = (blocks_todo > mmc->b_max) ? mmc->b_max : blocks_todo;
+ cur = (blocks_todo > mmc->cfg->b_max) ?
+ mmc->cfg->b_max : blocks_todo;
if(mmc_read_blocks(mmc, dst, start, cur) != cur)
return 0;
blocks_todo -= cur;
* specified.
*/
cmd.cmdarg = mmc_host_is_spi(mmc) ? 0 :
- (mmc->voltages & 0xff8000);
+ (mmc->cfg->voltages & 0xff8000);
if (mmc->version == SD_VERSION_2)
cmd.cmdarg |= OCR_HCS;
cmd->cmdarg = 0;
if (use_arg && !mmc_host_is_spi(mmc)) {
cmd->cmdarg =
- (mmc->voltages &
+ (mmc->cfg->voltages &
(mmc->op_cond_response & OCR_VOLTAGE_MASK)) |
(mmc->op_cond_response & OCR_ACCESS_MODE);
- if (mmc->host_caps & MMC_MODE_HC)
+ if (mmc->cfg->host_caps & MMC_MODE_HC)
cmd->cmdarg |= OCR_HCS;
}
err = mmc_send_cmd(mmc, cmd, NULL);
err = mmc_switch(mmc, EXT_CSD_CMD_SET_NORMAL, EXT_CSD_HS_TIMING, 1);
if (err)
- return err;
+ return err == SWITCH_ERR ? 0 : err;
/* Now check to see that it worked */
err = mmc_send_ext_csd(mmc, ext_csd);
return 0;
/* High Speed is set, there are two types: 52MHz and 26MHz */
- if (cardtype & MMC_HS_52MHZ)
+ if (cardtype & EXT_CSD_CARD_TYPE_52) {
+ if (cardtype & EXT_CSD_CARD_TYPE_DDR_52)
+ mmc->card_caps |= MMC_MODE_DDR_52MHz;
mmc->card_caps |= MMC_MODE_HS_52MHz | MMC_MODE_HS;
- else
+ } else {
mmc->card_caps |= MMC_MODE_HS;
+ }
return 0;
}
return 0;
}
+int mmc_select_hwpart(int dev_num, int hwpart)
+{
+ struct mmc *mmc = find_mmc_device(dev_num);
+ int ret;
+
+ if (!mmc)
+ return -1;
+
+ if (mmc->part_num == hwpart)
+ return 0;
+
+ if (mmc->part_config == MMCPART_NOAVAILABLE) {
+ printf("Card doesn't support part_switch\n");
+ return -1;
+ }
+
+ ret = mmc_switch_part(dev_num, hwpart);
+ if (ret)
+ return -1;
+
+ mmc->part_num = hwpart;
+
+ return 0;
+}
+
+
int mmc_switch_part(int dev_num, unsigned int part_num)
{
struct mmc *mmc = find_mmc_device(dev_num);
cd = board_mmc_getcd(mmc);
if (cd < 0) {
- if (mmc->ops->getcd)
- cd = mmc->ops->getcd(mmc);
+ if (mmc->cfg->ops->getcd)
+ cd = mmc->cfg->ops->getcd(mmc);
else
cd = 1;
}
* This can avoid furthur problem when the card runs in different
* mode between the host.
*/
- if (!((mmc->host_caps & MMC_MODE_HS_52MHz) &&
- (mmc->host_caps & MMC_MODE_HS)))
+ if (!((mmc->cfg->host_caps & MMC_MODE_HS_52MHz) &&
+ (mmc->cfg->host_caps & MMC_MODE_HS)))
return 0;
err = sd_switch(mmc, SD_SWITCH_SWITCH, 0, 1, (u8 *)switch_status);
static void mmc_set_ios(struct mmc *mmc)
{
- if (mmc->ops->set_ios)
- mmc->ops->set_ios(mmc);
+ if (mmc->cfg->ops->set_ios)
+ mmc->cfg->ops->set_ios(mmc);
}
void mmc_set_clock(struct mmc *mmc, uint clock)
{
- if (clock > mmc->f_max)
- clock = mmc->f_max;
+ if (clock > mmc->cfg->f_max)
+ clock = mmc->cfg->f_max;
- if (clock < mmc->f_min)
- clock = mmc->f_min;
+ if (clock < mmc->cfg->f_min)
+ clock = mmc->cfg->f_min;
mmc->clock = clock;
return err;
/* Restrict card's capabilities by what the host can do */
- mmc->card_caps &= mmc->host_caps;
+ mmc->card_caps &= mmc->cfg->host_caps;
if (IS_SD(mmc)) {
if (mmc->card_caps & MMC_MODE_4BIT) {
/* An array of possible bus widths in order of preference */
static unsigned ext_csd_bits[] = {
+ EXT_CSD_DDR_BUS_WIDTH_8,
+ EXT_CSD_DDR_BUS_WIDTH_4,
EXT_CSD_BUS_WIDTH_8,
EXT_CSD_BUS_WIDTH_4,
EXT_CSD_BUS_WIDTH_1,
/* An array to map CSD bus widths to host cap bits */
static unsigned ext_to_hostcaps[] = {
+ [EXT_CSD_DDR_BUS_WIDTH_4] = MMC_MODE_DDR_52MHz,
+ [EXT_CSD_DDR_BUS_WIDTH_8] = MMC_MODE_DDR_52MHz,
[EXT_CSD_BUS_WIDTH_4] = MMC_MODE_4BIT,
[EXT_CSD_BUS_WIDTH_8] = MMC_MODE_8BIT,
};
/* An array to map chosen bus width to an integer */
static unsigned widths[] = {
- 8, 4, 1,
+ 8, 4, 8, 4, 1,
};
for (idx=0; idx < ARRAY_SIZE(ext_csd_bits); idx++) {
* this bus width, if it's more than 1
*/
if (extw != EXT_CSD_BUS_WIDTH_1 &&
- !(mmc->host_caps & ext_to_hostcaps[extw]))
+ !(mmc->cfg->host_caps & ext_to_hostcaps[extw]))
continue;
err = mmc_switch(mmc, EXT_CSD_CMD_SET_NORMAL,
cmd.cmdidx = SD_CMD_SEND_IF_COND;
/* We set the bit if the host supports voltages between 2.7 and 3.6 V */
- cmd.cmdarg = ((mmc->voltages & 0xff8000) != 0) << 8 | 0xaa;
+ cmd.cmdarg = ((mmc->cfg->voltages & 0xff8000) != 0) << 8 | 0xaa;
cmd.resp_type = MMC_RSP_R7;
err = mmc_send_cmd(mmc, &cmd, NULL);
return 0;
}
-int mmc_register(struct mmc *mmc)
+/* not used any more */
+int __deprecated mmc_register(struct mmc *mmc)
{
+#if !defined(CONFIG_SPL_BUILD) || defined(CONFIG_SPL_LIBCOMMON_SUPPORT)
+ printf("%s is deprecated! use mmc_create() instead.\n", __func__);
+#endif
+ return -1;
+}
+
+struct mmc *mmc_create(const struct mmc_config *cfg, void *priv)
+{
+ struct mmc *mmc;
+
+ /* quick validation */
+ if (cfg == NULL || cfg->ops == NULL || cfg->ops->send_cmd == NULL ||
+ cfg->f_min == 0 || cfg->f_max == 0 || cfg->b_max == 0)
+ return NULL;
+
+ mmc = calloc(1, sizeof(*mmc));
+ if (mmc == NULL)
+ return NULL;
+
+ mmc->cfg = cfg;
+ mmc->priv = priv;
+
+ /* the following chunk was mmc_register() */
+
/* Setup dsr related values */
mmc->dsr_imp = 0;
mmc->dsr = 0xffffffff;
mmc->block_dev.block_read = mmc_bread;
mmc->block_dev.block_write = mmc_bwrite;
mmc->block_dev.block_erase = mmc_berase;
- if (!mmc->b_max)
- mmc->b_max = CONFIG_SYS_MMC_MAX_BLK_COUNT;
- INIT_LIST_HEAD (&mmc->link);
+ /* setup initial part type */
+ mmc->block_dev.part_type = mmc->cfg->part_type;
- list_add_tail (&mmc->link, &mmc_devices);
+ INIT_LIST_HEAD(&mmc->link);
- return 0;
+ list_add_tail(&mmc->link, &mmc_devices);
+
+ return mmc;
+}
+
+void mmc_destroy(struct mmc *mmc)
+{
+ /* only freeing memory for now */
+ free(mmc);
}
#ifdef CONFIG_PARTITIONS
int err;
/* we pretend there's no card when init is NULL */
- if (mmc_getcd(mmc) == 0 || mmc->ops->init == NULL) {
+ if (mmc_getcd(mmc) == 0 || mmc->cfg->ops->init == NULL) {
mmc->has_init = 0;
#if !defined(CONFIG_SPL_BUILD) || defined(CONFIG_SPL_LIBCOMMON_SUPPORT)
printf("MMC: no card present\n");
return 0;
/* made sure it's not NULL earlier */
- err = mmc->ops->init(mmc);
+ err = mmc->cfg->ops->init(mmc);
if (err)
return err;
int mmc_init(struct mmc *mmc)
{
int err = IN_PROGRESS;
- unsigned start = get_timer(0);
+ unsigned start;
if (mmc->has_init)
return 0;
+
+ start = get_timer(0);
+
if (!mmc->init_in_progress)
err = mmc_start_init(mmc);
list_for_each(entry, &mmc_devices) {
m = list_entry(entry, struct mmc, link);
- printf("%s: %d", m->name, m->block_dev.dev);
+ printf("%s: %d", m->cfg->name, m->block_dev.dev);
if (entry->next != &mmc_devices)
printf("%c ", separator);
return err;
return 0;
}
+
+/*
+ * Modify EXT_CSD[162] which is RST_n_FUNCTION based on the given value
+ * for enable. Note that this is a write-once field for non-zero values.
+ *
+ * Returns 0 on success.
+ */
+int mmc_set_rst_n_function(struct mmc *mmc, u8 enable)
+{
+ return mmc_switch(mmc, EXT_CSD_CMD_SET_NORMAL, EXT_CSD_RST_N_FUNCTION,
+ enable);
+}
#endif
projects / karo-tx-uboot.git / blobdiff