From dd11acaa749e19baea8077a8a9814cbad47ea6b0 Mon Sep 17 00:00:00 2001 From: Gerhard Sittig Date: Sat, 8 Mar 2014 19:46:18 +0100 Subject: [PATCH] usb: net: update README.usb to list all USB ethernet options - extend the discussion of USB network related config options such that all available adapter drivers are listed, and that the 'usb' command for the interactive prompt and scripting becomes available - suggest to *not* put individual IP configuration parameters into the exectuable, but instead to put them into external environment or fetch them from network Signed-off-by: Gerhard Sittig Acked-by: Simon Glass Acked-by: Marek Vasut --- doc/README.usb | 13 +++++++++++-- 1 file changed, 11 insertions(+), 2 deletions(-) diff --git a/doc/README.usb b/doc/README.usb index 65fb2886d9..bc768a3854 100644 --- a/doc/README.usb +++ b/doc/README.usb @@ -127,8 +127,14 @@ To enable USB Host Ethernet in U-Boot, your platform must of course support USB with CONFIG_CMD_USB enabled and working. You will need to add some config settings to your board header file: +#define CONFIG_CMD_USB /* the 'usb' interactive command */ #define CONFIG_USB_HOST_ETHER /* Enable USB Ethernet adapters */ -#define CONFIG_USB_ETHER_ASIX /* Asix, or whatever driver(s) you want */ + +and one or more of the following for individual adapter hardware: + +#define CONFIG_USB_ETHER_ASIX +#define CONFIG_USB_ETHER_MCS7830 +#define CONFIG_USB_ETHER_SMSC95XX As with built-in networking, you will also want to enable some network commands, for example: @@ -148,7 +154,10 @@ settings should start you off: You can also set the default IP address of your board and the server as well as the default file to load when a 'bootp' command is issued. -All of these can be obtained from the bootp server if not set. +However note that encoding these individual network settings into a +common exectuable is discouraged, as it leads to potential conflicts, +and all the parameters can either get stored in the board's external +environment, or get obtained from the bootp server if not set. #define CONFIG_IPADDR 10.0.0.2 (replace with your value) #define CONFIG_SERVERIP 10.0.0.1 (replace with your value) -- 2.39.2