4 * Copyright (C) 2013 Renesas Solutions Corp.
5 * Copyright (C) 2013 Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
7 * This program is free software; you can redistribute it and/or modify
8 * it under the terms of the GNU General Public License as published by
9 * the Free Software Foundation; version 2 of the License.
11 * This program is distributed in the hope that it will be useful,
12 * but WITHOUT ANY WARRANTY; without even the implied warranty of
13 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
14 * GNU General Public License for more details.
16 * You should have received a copy of the GNU General Public License
17 * along with this program; if not, write to the Free Software
18 * Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
21 #include <linux/mfd/tmio.h>
22 #include <linux/mmc/host.h>
23 #include <linux/mtd/partitions.h>
24 #include <linux/pinctrl/machine.h>
25 #include <linux/platform_device.h>
26 #include <linux/regulator/fixed.h>
27 #include <linux/regulator/machine.h>
28 #include <linux/smsc911x.h>
29 #include <linux/spi/spi.h>
30 #include <linux/spi/flash.h>
31 #include <mach/common.h>
32 #include <mach/irqs.h>
33 #include <mach/r8a7778.h>
34 #include <asm/mach/arch.h>
37 * CN9(Upper side) SCIF/RCAN selection
61 /* Dummy supplies, where voltage doesn't matter */
62 static struct regulator_consumer_supply dummy_supplies[] = {
63 REGULATOR_SUPPLY("vddvario", "smsc911x"),
64 REGULATOR_SUPPLY("vdd33a", "smsc911x"),
67 static struct smsc911x_platform_config smsc911x_data = {
68 .irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
69 .irq_type = SMSC911X_IRQ_TYPE_PUSH_PULL,
70 .flags = SMSC911X_USE_32BIT,
71 .phy_interface = PHY_INTERFACE_MODE_MII,
74 static struct resource smsc911x_resources[] = {
75 DEFINE_RES_MEM(0x18300000, 0x1000),
76 DEFINE_RES_IRQ(irq_pin(0)), /* IRQ 0 */
80 static struct rcar_phy_platform_data usb_phy_platform_data __initdata;
83 static struct sh_mobile_sdhi_info sdhi0_info = {
84 .tmio_caps = MMC_CAP_SD_HIGHSPEED,
85 .tmio_ocr_mask = MMC_VDD_165_195 | MMC_VDD_32_33 | MMC_VDD_33_34,
86 .tmio_flags = TMIO_MMC_HAS_IDLE_WAIT,
89 static struct sh_eth_plat_data ether_platform_data __initdata = {
91 .edmac_endian = EDMAC_LITTLE_ENDIAN,
92 .register_type = SH_ETH_REG_FAST_RCAR,
93 .phy_interface = PHY_INTERFACE_MODE_RMII,
95 * Although the LINK signal is available on the board, it's connected to
96 * the link/activity LED output of the PHY, thus the link disappears and
97 * reappears after each packet. We'd be better off ignoring such signal
98 * and getting the link state from the PHY indirectly.
104 static struct i2c_board_info i2c0_devices[] = {
106 I2C_BOARD_INFO("rx8581", 0x51),
111 static struct mtd_partition m25p80_spi_flash_partitions[] = {
119 static struct flash_platform_data spi_flash_data = {
122 .parts = m25p80_spi_flash_partitions,
123 .nr_parts = ARRAY_SIZE(m25p80_spi_flash_partitions),
126 static struct spi_board_info spi_board_info[] __initdata = {
128 .modalias = "m25p80",
129 .max_speed_hz = 104000000,
133 .platform_data = &spi_flash_data,
138 static struct sh_mmcif_plat_data sh_mmcif_plat = {
140 .ocr = MMC_VDD_165_195 | MMC_VDD_32_33 | MMC_VDD_33_34,
141 .caps = MMC_CAP_4_BIT_DATA |
146 static const struct pinctrl_map bockw_pinctrl_map[] = {
148 PIN_MAP_MUX_GROUP_DEFAULT("r8a777x-ether", "pfc-r8a7778",
149 "ether_rmii", "ether"),
151 PIN_MAP_MUX_GROUP_DEFAULT("sh-hspi.0", "pfc-r8a7778",
154 PIN_MAP_MUX_GROUP_DEFAULT("sh_mmcif", "pfc-r8a7778",
156 PIN_MAP_MUX_GROUP_DEFAULT("sh_mmcif", "pfc-r8a7778",
159 PIN_MAP_MUX_GROUP_DEFAULT("sh-sci.0", "pfc-r8a7778",
160 "scif0_data_a", "scif0"),
161 PIN_MAP_MUX_GROUP_DEFAULT("sh-sci.0", "pfc-r8a7778",
162 "scif0_ctrl", "scif0"),
164 PIN_MAP_MUX_GROUP_DEFAULT("ehci-platform", "pfc-r8a7778",
166 PIN_MAP_MUX_GROUP_DEFAULT("ehci-platform", "pfc-r8a7778",
169 PIN_MAP_MUX_GROUP_DEFAULT("sh_mobile_sdhi.0", "pfc-r8a7778",
170 "sdhi0_data4", "sdhi0"),
171 PIN_MAP_MUX_GROUP_DEFAULT("sh_mobile_sdhi.0", "pfc-r8a7778",
172 "sdhi0_ctrl", "sdhi0"),
173 PIN_MAP_MUX_GROUP_DEFAULT("sh_mobile_sdhi.0", "pfc-r8a7778",
174 "sdhi0_cd", "sdhi0"),
175 PIN_MAP_MUX_GROUP_DEFAULT("sh_mobile_sdhi.0", "pfc-r8a7778",
176 "sdhi0_wp", "sdhi0"),
179 #define FPGA 0x18200000
181 #define PFC 0xfffc0000
183 static void __init bockw_init(void)
187 r8a7778_clock_init();
188 r8a7778_init_irq_extpin(1);
189 r8a7778_add_standard_devices();
190 r8a7778_add_usb_phy_device(&usb_phy_platform_data);
191 r8a7778_add_ether_device(ðer_platform_data);
192 r8a7778_add_i2c_device(0);
193 r8a7778_add_hspi_device(0);
194 r8a7778_add_mmc_device(&sh_mmcif_plat);
196 i2c_register_board_info(0, i2c0_devices,
197 ARRAY_SIZE(i2c0_devices));
198 spi_register_board_info(spi_board_info,
199 ARRAY_SIZE(spi_board_info));
200 pinctrl_register_mappings(bockw_pinctrl_map,
201 ARRAY_SIZE(bockw_pinctrl_map));
202 r8a7778_pinmux_init();
205 base = ioremap_nocache(FPGA, SZ_1M);
210 * IRQ0/1 is cascaded interrupt from FPGA.
211 * it should be cared in the future
212 * Now, it is assuming IRQ0 was used only from SMSC.
214 u16 val = ioread16(base + IRQ0MR);
215 val &= ~(1 << 4); /* enable SMSC911x */
216 iowrite16(val, base + IRQ0MR);
219 regulator_register_fixed(0, dummy_supplies,
220 ARRAY_SIZE(dummy_supplies));
222 platform_device_register_resndata(
223 &platform_bus, "smsc911x", -1,
224 smsc911x_resources, ARRAY_SIZE(smsc911x_resources),
225 &smsc911x_data, sizeof(smsc911x_data));
229 base = ioremap_nocache(PFC, 0x200);
234 * SDHI CD/WP pin needs pull-up
236 iowrite32(ioread32(base + PUPR4) | (3 << 26), base + PUPR4);
239 r8a7778_sdhi_init(0, &sdhi0_info);
243 static const char *bockw_boards_compat_dt[] __initdata = {
248 DT_MACHINE_START(BOCKW_DT, "bockw")
249 .init_early = r8a7778_init_delay,
250 .init_irq = r8a7778_init_irq_dt,
251 .init_machine = bockw_init,
252 .init_time = shmobile_timer_init,
253 .dt_compat = bockw_boards_compat_dt,
254 .init_late = r8a7778_init_late,