#define UNUSABLE_ERR -17 /* Unusable Card */
#define COMM_ERR -18 /* Communications Error */
#define TIMEOUT -19
+#define IN_PROGRESS -20 /* operation is in progress */
#define MMC_CMD_GO_IDLE_STATE 0
#define MMC_CMD_SEND_OP_COND 1
int (*getcd)(struct mmc *mmc);
int (*getwp)(struct mmc *mmc);
uint b_max;
+ char op_cond_pending; /* 1 if we are waiting on an op_cond command */
+ char init_in_progress; /* 1 if we have done mmc_start_init() */
+ char preinit; /* start init as early as possible */
+ uint op_cond_response; /* the response byte from the last op_cond */
};
int mmc_register(struct mmc *mmc);
/* Function to send commands to open/close the specified boot partition */
int mmc_boot_part_access(struct mmc *mmc, u8 ack, u8 part_num, u8 access);
+/**
+ * Start device initialization and return immediately; it does not block on
+ * polling OCR (operation condition register) status. Then you should call
+ * mmc_init, which would block on polling OCR status and complete the device
+ * initializatin.
+ *
+ * @param mmc Pointer to a MMC device struct
+ * @return 0 on success, IN_PROGRESS on waiting for OCR status, <0 on error.
+ */
+int mmc_start_init(struct mmc *mmc);
+
+/**
+ * Set preinit flag of mmc device.
+ *
+ * This will cause the device to be pre-inited during mmc_initialize(),
+ * which may save boot time if the device is not accessed until later.
+ * Some eMMC devices take 200-300ms to init, but unfortunately they
+ * must be sent a series of commands to even get them to start preparing
+ * for operation.
+ *
+ * @param mmc Pointer to a MMC device struct
+ * @param preinit preinit flag value
+ */
+void mmc_set_preinit(struct mmc *mmc, int preinit);
+
#ifdef CONFIG_GENERIC_MMC
#define mmc_host_is_spi(mmc) ((mmc)->host_caps & MMC_MODE_SPI)
struct mmc *mmc_spi_init(uint bus, uint cs, uint speed, uint mode);