omap-common: SYS_BOOT fallback logic correction and support for more devices

[karo-tx-uboot.git] / doc / README.ppc440

diff --git a/doc/README.ppc440 b/doc/README.ppc440
index 0a5f99fb1343013c60f0ba47fd7ea7a5329195d9..dd8ccaad0e7ae32ef25636faa4403c44143047c0 100644 (file)
--- a/doc/README.ppc440
+++ b/doc/README.ppc440
@@ -77,18 +77,12 @@ This is controlled with the CONFIG_SYS_EXT_SERIAL_CLOCK flag. When using
 internal clocking, the "ideal baud rate" settings in the 440GP
 user manual are automatically calculated.
 
 internal clocking, the "ideal baud rate" settings in the 440GP
 user manual are automatically calculated.
 

-CONFIG_SERIAL_SOFTWARE_FIFO enables interrupt-driven serial operation.
-But the last time I checked, interrupts were initialized after the
-serial port causing the interrupt handler to be removed from the
-handler table. This will probably be fixed soon ... or fix it
-yourself and submit a patch :-)
-

 
 I2C
 =================
 
 The i2c utilities have been tested on both Rev B. and Rev C. and
 
 I2C
 =================
 
 The i2c utilities have been tested on both Rev B. and Rev C. and

-look good. The iprobe command implementation has been updated to
+look good. The 'i2c probe' command implementation has been updated to

 allow for 'skipped' addresses. Some i2c slaves are write only and
 cause problems when a probe (read) is performed (for example the
 CDCV850 clock controller at address 0x69 on the ebony board).
 allow for 'skipped' addresses. Some i2c slaves are write only and
 cause problems when a probe (read) is performed (for example the
 CDCV850 clock controller at address 0x69 on the ebony board).


@@ -97,7 +91,7 @@ To prevent probing certain addresses you can define the
 CONFIG_SYS_I2C_NOPROBES macro in your board-specific header file. When
 defined, all specified addresses are skipped during a probe.
 The addresses that are skipped will be displayed in the output
 CONFIG_SYS_I2C_NOPROBES macro in your board-specific header file. When
 defined, all specified addresses are skipped during a probe.
 The addresses that are skipped will be displayed in the output

-of the iprobe command.
+of the 'i2c probe' command.

 
 For example, to prevent probing address 0x69, define the macro as
 follows:
 
 For example, to prevent probing address 0x69, define the macro as
 follows: