remove the documentation for the legacy CDROM drivers

[karo-tx-linux.git] / Documentation / cdrom / sjcd

diff --git a/Documentation/cdrom/sjcd b/Documentation/cdrom/sjcd
deleted file mode 100644 (file)
index 74a1484..0000000
--- a/Documentation/cdrom/sjcd
+++ /dev/null
@@ -1,60 +0,0 @@
- -- Documentation/cdrom/sjcd
-                               80% of the work takes 20% of the time,
-                               20% of the work takes 80% of the time...
-                                               (Murphy's law)
-
-                               Once started, training can not be stopped...
-                                               (Star Wars)
-
-This is the README for the sjcd cdrom driver, version 1.6.
-
-This file is meant as a tips & tricks edge for the usage of the SANYO CDR-H94A
-cdrom drive. It will grow as the questions arise. ;-)
-For info on configuring the ISP16 sound card look at Documentation/cdrom/isp16.
-
-The driver should work with any of the Panasonic, Sony or Mitsumi style
-CDROM interfaces.
-The cdrom interface on Media Magic's soft configurable sound card ISP16,
-which used to be included in the driver, is now supported in a separate module.
-This initialisation module will probably also work with other interfaces
-based on an OPTi 82C928 or 82C929 chip (like MAD16 and Mozart): see the
-documentation Documentation/cdrom/isp16.
-
-The device major for sjcd is 18, and minor is 0. Create a block special
-file in your /dev directory (e.g., /dev/sjcd) with these numbers.
-(For those who don't know, being root and doing the following should do
-the trick:
-  mknod -m 644 /dev/sjcd b 18 0
-and mount the cdrom by /dev/sjcd).
-
-The default configuration parameters are:
-  base address 0x340
-  no irq
-  no dma
-(Actually the CDR-H94A doesn't know how to use irq and dma.)
-As of version 1.2, setting base address at boot time is supported
-through the use of command line options: type at the "boot:" prompt:
-  linux sjcd=<base_address>
-(where you would use the kernel labeled "linux" in lilo's configuration
-file /etc/lilo.conf). You could also use 'append="sjcd=<configuration_info>"'
-in the appropriate section of /etc/lilo.conf
-If you're building a kernel yourself you can set your default base
-i/o address with SJCD_BASE_ADDR in /usr/src/linux/drivers/cdrom/sjcd.h.
-
-The sjcd driver supports being loaded as a module. The following
-command will set the base i/o address on the fly (assuming you
-have installed the module in an appropriate place).
-  insmod sjcd.o sjcd_base=<base_address>
-
-
-Have fun!
-
-If something is wrong, please email to         vadim@rbrf.ru
-                                       or      vadim@ipsun.ras.ru
-                                       or      model@cecmow.enet.dec.com
-                                       or      H.T.M.v.d.Maarel@marin.nl
-
-It happens sometimes that Vadim is not reachable by mail. For these
-instances, Eric van der Maarel will help too.
-
-               Vadim V. Model, Eric van der Maarel, Eberhard Moenkeberg