andes_spi: add andes_spi interface

[karo-tx-uboot.git] / README

diff --git a/README b/README
index 2da0f96abee36c008b8d8ae1a49d24baa97b06bc..294b39eda248a8bc3b74cec798ab9a5dcd6253c8 100644 (file)
--- a/README
+++ b/README
@@ -442,6 +442,16 @@ The following options need to be configured:
                crash. This is needed for buggy hardware (uc101) where
                no pull down resistor is connected to the signal IDE5V_DD7.
 
+               CONFIG_MACH_TYPE        [relevant for ARM only][mandatory]
+
+               This setting is mandatory for all boards that have only one
+               machine type and must be used to specify the machine type
+               number as it appears in the ARM machine registry
+               (see http://www.arm.linux.org.uk/developer/machines/).
+               Only boards that have multiple machine types supported
+               in a single configuration file and the machine type is
+               runtime discoverable, do not have to use this setting.
+
 - vxWorks boot parameters:
 
                bootvx constructs a valid bootline using the following
@@ -1054,6 +1064,15 @@ The following options need to be configured:
                enabled with CONFIG_CMD_MMC. The MMC driver also works with
                the FAT fs. This is enabled with CONFIG_CMD_FAT.
 
+               CONFIG_SH_MMCIF
+               Support for Renesas on-chip MMCIF controller
+
+                       CONFIG_SH_MMCIF_ADDR
+                       Define the base address of MMCIF registers
+
+                       CONFIG_SH_MMCIF_CLK
+                       Define the clock frequency for MMCIF
+
 - Journaling Flash filesystem support:
                CONFIG_JFFS2_NAND, CONFIG_JFFS2_NAND_OFF, CONFIG_JFFS2_NAND_SIZE,
                CONFIG_JFFS2_NAND_DEV
@@ -2948,6 +2967,12 @@ Low Level (hardware related) configuration options:
                one, specify here. Note that the value must resolve
                to something your driver can deal with.
 
+- CONFIG_SYS_DDR_RAW_TIMING
+               Get DDR timing information from other than SPD. Common with
+               soldered DDR chips onboard without SPD. DDR raw timing
+               parameters are extracted from datasheet and hard-coded into
+               header files or board specific files.
+
 - CONFIG_SYS_83XX_DDR_USES_CS0
                Only for 83xx systems. If specified, then DDR should
                be configured using CS0 and CS1 instead of CS2 and CS3.
@@ -3299,6 +3324,15 @@ List of environment variables (most likely not complete):
                  This can be used to load and uncompress arbitrary
                  data.
 
+  fdt_high     - if set this restricts the maximum address that the
+                 flattened device tree will be copied into upon boot.
+                 If this is set to the special value 0xFFFFFFFF then
+                 the fdt will not be copied at all on boot.  For this
+                 to work it must reside in writable memory, have
+                 sufficient padding on the end of it for u-boot to
+                 add the information it needs into it, and the memory
+                 must be accessible by the kernel.
+
   i2cfast      - (PPC405GP|PPC405EP only)
                  if set to 'y' configures Linux I2C driver for fast
                  mode (400kHZ). This environment variable is used in