"working". In fact, many of them are used in production systems.
In case of problems see the CHANGELOG and CREDITS files to find out
-who contributed the specific port. The MAINTAINERS file lists board
+who contributed the specific port. The boards.cfg file lists board
maintainers.
Note: There is no CHANGELOG file in the actual U-Boot source tree;
to compress the specified memory at its best effort.
- Compression support:
+ CONFIG_GZIP
+
+ Enabled by default to support gzip compressed images.
+
CONFIG_BZIP2
If this option is set, support for bzip2 compressed
then calculate the amount of needed dynamic memory (ensuring
the appropriate CONFIG_SYS_MALLOC_LEN value).
+ CONFIG_LZO
+
+ If this option is set, support for LZO compressed images
+ is included.
+
- MII/PHY support:
CONFIG_PHY_ADDR
Set for the SPL on PPC mpc8xxx targets, support for
arch/powerpc/cpu/mpc8xxx/ddr/libddr.o in SPL binary.
+ CONFIG_SPL_COMMON_INIT_DDR
+ Set for common ddr init with serial presence detect in
+ SPL binary.
+
CONFIG_SYS_NAND_5_ADDR_CYCLE, CONFIG_SYS_NAND_PAGE_COUNT,
CONFIG_SYS_NAND_PAGE_SIZE, CONFIG_SYS_NAND_OOBSIZE,
CONFIG_SYS_NAND_BLOCK_SIZE, CONFIG_SYS_NAND_BAD_BLOCK_POS,
option to re-enable it. This will affect the output of the
bootm command when booting a FIT image.
+- TPL framework
+ CONFIG_TPL
+ Enable building of TPL globally.
+
+ CONFIG_TPL_PAD_TO
+ Image offset to which the TPL should be padded before appending
+ the TPL payload. By default, this is defined as
+ CONFIG_SPL_MAX_SIZE, or 0 if CONFIG_SPL_MAX_SIZE is undefined.
+ CONFIG_SPL_PAD_TO must be either 0, meaning to append the SPL
+ payload without any padding, or >= CONFIG_SPL_MAX_SIZE.
+
Modem Support:
--------------
that is executed before the actual U-Boot. E.g. when
compiling a NAND SPL.
+- CONFIG_TPL_BUILD
+ Modifies the behaviour of start.S when compiling a loader
+ that is executed after the SPL and before the actual U-Boot.
+ It is loaded by the SPL.
+
- CONFIG_SYS_MPC85XX_NO_RESETVEC
Only for 85xx systems. If this variable is specified, the section
.resetvec is not kept and the section .bootpg is placed in the
* For major contributions, your entry to the CREDITS file
-* When you add support for a new board, don't forget to add this
- board to the MAINTAINERS file, too.
+* When you add support for a new board, don't forget to add a
+ maintainer e-mail address to the boards.cfg file, too.
* If your patch adds new configuration options, don't forget to
document these in the README file.