*
* HWMOD_SWSUP_SIDLE: omap_hwmod code should manually bring module in and out
* of idle, rather than relying on module smart-idle
- * HWMOD_SWSUP_MSTDBY: omap_hwmod code should manually bring module in and out
- * of standby, rather than relying on module smart-standby
+ * HWMOD_SWSUP_MSTANDBY: omap_hwmod code should manually bring module in and
+ * out of standby, rather than relying on module smart-standby
* HWMOD_INIT_NO_RESET: don't reset this module at boot - important for
* SDRAM controller, etc. XXX probably belongs outside the main hwmod file
* XXX Should be HWMOD_SETUP_NO_RESET
* correctly, or this is being abused to deal with some PM latency
* issues -- but we're currently suffering from a shortage of
* folks who are able to track these issues down properly.
+ * HWMOD_FORCE_MSTANDBY: Always keep MIDLEMODE bits cleared so that device
+ * is kept in force-standby mode. Failing to do so causes PM problems
+ * with musb on OMAP3630 at least. Note that musb has a dedicated register
+ * to control MSTANDBY signal when MIDLEMODE is set to force-standby.
*/
#define HWMOD_SWSUP_SIDLE (1 << 0)
#define HWMOD_SWSUP_MSTANDBY (1 << 1)
#define HWMOD_16BIT_REG (1 << 8)
#define HWMOD_EXT_OPT_MAIN_CLK (1 << 9)
#define HWMOD_BLOCK_WFI (1 << 10)
+#define HWMOD_FORCE_MSTANDBY (1 << 11)
/*
* omap_hwmod._int_flags definitions