dm: at91: Convert snapper9260 to use driver model

[karo-tx-uboot.git] / board / bluewater / snapper9260 / snapper9260.c

diff --git a/board/bluewater/snapper9260/snapper9260.c b/board/bluewater/snapper9260/snapper9260.c
index bfde1291a59c8138740a76ae2c6b21e949b6a23e..95633b0d2e87074fd07d6f3ddb09852ac93622c5 100644 (file)
--- a/board/bluewater/snapper9260/snapper9260.c
+++ b/board/bluewater/snapper9260/snapper9260.c
@@ -9,12 +9,15 @@
  */
 
 #include <common.h>
+#include <dm.h>
 #include <asm/io.h>
+#include <asm/gpio.h>
 #include <asm/arch/at91sam9260_matrix.h>
 #include <asm/arch/at91sam9_smc.h>
 #include <asm/arch/at91_common.h>
 #include <asm/arch/at91_pmc.h>
 #include <asm/arch/gpio.h>
+#include <asm/arch/atmel_serial.h>
 #include <net.h>
 #include <netdev.h>
 #include <i2c.h>
@@ -95,10 +98,12 @@ static void nand_hw_init(void)
               &smc->cs[3].mode);
 
        /* Configure RDY/BSY */
-       at91_set_gpio_input(CONFIG_SYS_NAND_READY_PIN, 1);
+       gpio_request(CONFIG_SYS_NAND_READY_PIN, "nand_rdy");
+       gpio_direction_input(CONFIG_SYS_NAND_READY_PIN);
 
        /* Enable NandFlash */
-       at91_set_gpio_output(CONFIG_SYS_NAND_ENABLE_PIN, 1);
+       gpio_request(CONFIG_SYS_NAND_ENABLE_PIN, "nand_ce");
+       gpio_direction_output(CONFIG_SYS_NAND_ENABLE_PIN, 1);
 }
 
 int board_init(void)
@@ -140,3 +145,12 @@ int dram_init(void)
 void reset_phy(void)
 {
 }
+
+static struct atmel_serial_platdata at91sam9260_serial_plat = {
+       .base_addr = ATMEL_BASE_DBGU,
+};
+
+U_BOOT_DEVICE(at91sam9260_serial) = {
+       .name   = "serial_atmel",
+       .platdata = &at91sam9260_serial_plat,
+};