at91sam9260ek: move board id setup to config header

[karo-tx-uboot.git] / include / configs / PM828.h

diff --git a/include/configs/PM828.h b/include/configs/PM828.h
index 3053ad4745c12d5bf06e1c787d4ea5e77b17052a..c37aafdd47a2c3e19126272965ce2deca8a72c09 100644 (file)
--- a/include/configs/PM828.h
+++ b/include/configs/PM828.h
@@ -100,16 +100,13 @@
  *
  * if CONFIG_ETHER_ON_SCC is selected, then
  *   - CONFIG_ETHER_INDEX must be set to the channel number (1-4)
- *   - CONFIG_NET_MULTI must not be defined
  *
  * if CONFIG_ETHER_ON_FCC is selected, then
  *   - one or more CONFIG_ETHER_ON_FCCx (x=1,2,3) must also be selected
- *   - CONFIG_NET_MULTI must be defined
  *
  * if CONFIG_ETHER_NONE is defined, then either the ethernet routines must be
  * defined elsewhere (as for the console), or CONFIG_CMD_NET must be unset.
  */
-#define CONFIG_NET_MULTI
 #undef CONFIG_ETHER_NONE               /* define if ether on something else */
 
 #undef CONFIG_ETHER_ON_SCC             /* define if ether on SCC       */
@@ -203,8 +200,6 @@
 
 #define CONFIG_SYS_HZ          1000            /* decrementer freq: 1 ms ticks */
 
-#define CONFIG_SYS_BAUDRATE_TABLE      { 9600, 19200, 38400, 57600, 115200 }
-
 #define CONFIG_SYS_RESET_ADDRESS 0xFDFFFFFC    /* "bad" address                */
 
 /*
@@ -287,9 +282,8 @@
  * Definitions for initial stack pointer and data area (in DPRAM)
  */
 #define CONFIG_SYS_INIT_RAM_ADDR       CONFIG_SYS_IMMR
-#define CONFIG_SYS_INIT_RAM_END        0x4000  /* End of used area in DPRAM    */
-#define CONFIG_SYS_GBL_DATA_SIZE       128 /* size in bytes reserved for initial data*/
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_INIT_RAM_SIZE       0x4000  /* Size of used area in DPRAM   */
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
 /*-----------------------------------------------------------------------