* the MPL VCMA9 is equipped with an ATMEL 24C256 EEPROM at
* address 0x50 with 16bit addressing
*/
-#define CONFIG_HARD_I2C /* I2C with hardware support */
-#define CONFIG_SYS_I2C_SPEED 100000 /* I2C speed */
-#define CONFIG_SYS_I2C_SLAVE 0x7F /* I2C slave addr */
+#define CONFIG_SYS_I2C
/* we use the built-in I2C controller */
-#define CONFIG_DRIVER_S3C24X0_I2C
+#define CONFIG_SYS_I2C_S3C24X0
+#define CONFIG_SYS_I2C_S3C24X0_SPEED 100000 /* I2C speed */
+#define CONFIG_SYS_I2C_S3C24X0_SLAVE 0x7F /* I2C slave addr */
#define CONFIG_SYS_I2C_EEPROM_ADDR 0x50
#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 2
#if defined(CONFIG_CMD_KGDB)
/* speed to run kgdb serial port */
#define CONFIG_KGDB_BAUDRATE 115200
-/* what's this ? it's not used anywhere */
-#define CONFIG_KGDB_SER_INDEX 2 /* which serial port to use */
#endif
/* Miscellaneous configurable options */
#define CONFIG_SYS_LOAD_ADDR 0x30800000
/* we configure PWM Timer 4 to 1ms 1000Hz */
-#define CONFIG_SYS_HZ 1000
/* support additional compression methods */
#define CONFIG_BZIP2