imx: mx6: unify source code for TX6Q and TX6DL

[karo-tx-uboot.git] / include / configs / p3p440.h

diff --git a/include/configs/p3p440.h b/include/configs/p3p440.h
index 4a2e420236eadd59edf860f33a829a1e65709a04..d7b1ca203a693445970217ee41656e557f3e220e 100644 (file)
--- a/include/configs/p3p440.h
+++ b/include/configs/p3p440.h
@@ -61,10 +61,9 @@
  * Initial RAM & stack pointer (placed in internal SRAM)
  *----------------------------------------------------------------------*/
 #define CONFIG_SYS_INIT_RAM_ADDR       CONFIG_SYS_ISRAM_BASE  /* Initial RAM address   */
-#define CONFIG_SYS_INIT_RAM_END        0x2000      /* End of used area in RAM  */
-#define CONFIG_SYS_GBL_DATA_SIZE       128         /* num bytes initial data   */
+#define CONFIG_SYS_INIT_RAM_SIZE       0x2000      /* Size of used area in RAM */
 
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
 #define CONFIG_SYS_MONITOR_LEN         (256 * 1024)    /* Reserve 256 kB for Mon*/
@@ -172,7 +171,6 @@
 #define CONFIG_PHY_ADDR                0x1c    /* PHY address                  */
 #define CONFIG_HAS_ETH1
 #define CONFIG_PHY1_ADDR       0x1d    /* EMAC1 PHY address            */
-#define CONFIG_NET_MULTI       1
 #define CONFIG_SYS_RX_ETH_BUFFER       32      /* Number of ethernet rx buffers & descriptors */
 
 #define CONFIG_NETCONSOLE              /* include NetConsole support   */
@@ -321,14 +319,6 @@
  */
 #define CONFIG_SYS_BOOTMAPSZ           (8 << 20)       /* Initial Memory map for Linux */
 
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define BOOTFLAG_COLD  0x01            /* Normal Power-On: Boot from FLASH     */
-#define BOOTFLAG_WARM  0x02            /* Software reboot                      */
-
 #if defined(CONFIG_CMD_KGDB)
 #define CONFIG_KGDB_BAUDRATE   230400  /* speed to run kgdb serial port */
 #define CONFIG_KGDB_SER_INDEX  2       /* which serial port to use */