clocked at 32KHz each. Clkout1 is always on, Clkout2 can off
by control register.
+config COMMON_CLK_SCPI
+ tristate "Clock driver controlled via SCPI interface"
+ depends on ARM_SCPI_PROTOCOL || COMPILE_TEST
+ ---help---
+ This driver provides support for clocks that are controlled
+ by firmware that implements the SCPI interface.
+
+ This driver uses SCPI Message Protocol to interact with the
+ firmware providing all the clock controls.
+
config COMMON_CLK_SI5351
tristate "Clock driver for SiLabs 5351A/B/C"
depends on I2C
This driver supports Silicon Labs 570/571/598/599 programmable
clock generators.
+config COMMON_CLK_CDCE925
+ tristate "Clock driver for TI CDCE925 devices"
+ depends on I2C
+ depends on OF
+ select REGMAP_I2C
+ help
+ ---help---
+ This driver supports the TI CDCE925 programmable clock synthesizer.
+ The chip contains two PLLs with spread-spectrum clocking support and
+ five output dividers. The driver only supports the following setup,
+ and uses a fixed setting for the output muxes.
+ Y1 is derived from the input clock
+ Y2 and Y3 derive from PLL1
+ Y4 and Y5 derive from PLL2
+ Given a target output frequency, the driver will set the PLL and
+ divider to best approximate the desired output.
+
config COMMON_CLK_S2MPS11
tristate "Clock driver for S2MPS1X/S5M8767 MFD"
depends on MFD_SEC_CORE
config CLK_QORIQ
bool "Clock driver for Freescale QorIQ platforms"
- depends on (PPC_E500MC || ARM) && OF
+ depends on (PPC_E500MC || ARM || ARM64) && OF
---help---
This adds the clock driver support for Freescale QorIQ platforms
using common clock framework.
---help---
This driver supports TI CDCE706 programmable 3-PLL clock synthesizer.
+source "drivers/clk/bcm/Kconfig"
+source "drivers/clk/hisilicon/Kconfig"
source "drivers/clk/qcom/Kconfig"
endmenu
-source "drivers/clk/bcm/Kconfig"
source "drivers/clk/mvebu/Kconfig"
source "drivers/clk/samsung/Kconfig"
+source "drivers/clk/tegra/Kconfig"