Doc: usb: ci-hdrc-usb2: add tx(rx)-burst-config-dword for binding doc

It is used to override the default setting for burst size, changing
burst size takes effect only when the SBUSCFG.AHBBRST = 0.

Signed-off-by: Peter Chen <peter.chen@freescale.com>

diff --git a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
index d52a747fb859943da71fbe6560ebb3e9276cef4a..d71ef07bca5d1a3505ecab53f0b84bc8e5d12fc1 100644 (file)
--- a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
+++ b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
@@ -37,6 +37,14 @@ Optional properties:
   property is used to change AHB burst configuration, check the chipidea
   spec for meaning of each value. If this property is not existed, it
   will use the reset value.
+- tx-burst-size-dword: it is vendor dependent, the tx burst size in dword
+  (4 bytes), This register represents the maximum length of a the burst
+  in 32-bit words while moving data from system memory to the USB
+  bus, changing this value takes effect only the SBUSCFG.AHBBRST is 0.
+- rx-burst-size-dword: it is vendor dependent, the rx burst size in dword
+  (4 bytes), This register represents the maximum length of a the burst
+  in 32-bit words while moving data from the USB bus to system memory,
+  changing this value takes effect only the SBUSCFG.AHBBRST is 0.
 
 Example:
 
@@ -51,4 +59,6 @@ Example:
                gadget-itc-setting = <0x4>; /* 4 micro-frames */
                 /* Incremental burst of unspecified length */
                ahb-burst-config = <0x0>;
+               tx-burst-size-dword = <0x10>; /* 64 bytes */
+               rx-burst-size-dword = <0x10>;
        };