powerpc/85xx: add missing QMAN frequency calculation

[karo-tx-uboot.git] / README

diff --git a/README b/README
index 19da9c81eb39f50e8097886550da2f23c7f4d8bd..0d37d561d9f929a3de64664d9da0e63ca8cfd444 100644 (file)
--- a/README
+++ b/README
@@ -930,6 +930,13 @@ The following options need to be configured:
 
                XXX - this list needs to get updated!
 
+- Regular expression support:
+               CONFIG_REGEX
+                If this variable is defined, U-Boot is linked against
+                the SLRE (Super Light Regular Expression) library,
+                which adds regex support to some commands, as for
+                example "env grep" and "setexpr".
+
 - Device tree:
                CONFIG_OF_CONTROL
                If this variable is defined, U-Boot will use a device tree
@@ -2835,7 +2842,7 @@ FIT uImage format:
                Maximum size in memory allocated to the SPL, BSS included.
                When defined, the linker checks that the actual memory
                used by SPL from _start to __bss_end does not exceed it.
-               CONFIG_SPL_MAX_FOOTPRINT and CONFIG_SPL_MAX_BSS_SIZE
+               CONFIG_SPL_MAX_FOOTPRINT and CONFIG_SPL_BSS_MAX_SIZE
                must not be both defined at the same time.
 
                CONFIG_SPL_MAX_SIZE
@@ -2858,7 +2865,7 @@ FIT uImage format:
                Maximum size in memory allocated to the SPL BSS.
                When defined, the linker checks that the actual memory used
                by SPL from __bss_start to __bss_end does not exceed it.
-               CONFIG_SPL_MAX_FOOTPRINT and CONFIG_SPL_MAX_BSS_SIZE
+               CONFIG_SPL_MAX_FOOTPRINT and CONFIG_SPL_BSS_MAX_SIZE
                must not be both defined at the same time.
 
                CONFIG_SPL_STACK
@@ -3248,6 +3255,15 @@ Configuration Settings:
                digits and dots.  Recommended value: 45 (9..1) for 80
                column displays, 15 (3..1) for 40 column displays.
 
+- CONFIG_FLASH_VERIFY
+               If defined, the content of the flash (destination) is compared
+               against the source after the write operation. An error message
+               will be printed when the contents are not identical.
+               Please note that this option is useless in nearly all cases,
+               since such flash programming errors usually are detected earlier
+               while unprotecting/erasing/programming. Please only enable
+               this option if you really know what you are doing.
+
 - CONFIG_SYS_RX_ETH_BUFFER:
                Defines the number of Ethernet receive buffers. On some
                Ethernet controllers it is recommended to set this value