zynq: Move CONFIG_SYS_SDRAM_SIZE to pre-board configs

[karo-tx-uboot.git] / README

diff --git a/README b/README
index 3c233db068c42e004c2350efecc40586ca149b8b..8f0b38cbf38b16de6f2a9d8707cde096f3b52b51 100644 (file)
--- a/README
+++ b/README
@@ -818,6 +818,22 @@ The following options need to be configured:
                as a convenience, when switching between booting from
                RAM and NFS.
 
+- Bootcount:
+               CONFIG_BOOTCOUNT_LIMIT
+               Implements a mechanism for detecting a repeating reboot
+               cycle, see:
+               http://www.denx.de/wiki/view/DULG/UBootBootCountLimit
+
+               CONFIG_BOOTCOUNT_ENV
+               If no softreset save registers are found on the hardware
+               "bootcount" is stored in the environment. To prevent a
+               saveenv on all reboots, the environment variable
+               "upgrade_available" is used. If "upgrade_available" is
+               0, "bootcount" is always 0, if "upgrade_available" is
+               1 "bootcount" is incremented in the environment.
+               So the Userspace Applikation must set the "upgrade_available"
+               and "bootcount" variable to 0, if a boot was successfully.
+
 - Pre-Boot Commands:
                CONFIG_PREBOOT
 
@@ -4394,6 +4410,9 @@ Low Level (hardware related) configuration options:
 
                NOTE : currently only supported on AM335x platforms.
 
+- CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC:
+               Enables the RTC32K OSC on AM33xx based plattforms
+
 Freescale QE/FMAN Firmware Support:
 -----------------------------------