/*
- * Copyright 2009 Freescale Semiconductor.
+ * Copyright 2009-2010 Freescale Semiconductor.
*
* (C) Copyright 2002 Scott McNutt <smcnutt@artesyncp.com>
*
#include <pci.h>
#include <asm/processor.h>
#include <asm/mmu.h>
+#include <asm/cache.h>
#include <asm/immap_85xx.h>
#include <asm/fsl_pci.h>
#include <asm/fsl_ddr_sdram.h>
#include <fsl_esdhc.h>
#include "bcsr.h"
+#if defined(CONFIG_PQ_MDS_PIB)
+#include "../common/pq-mds-pib.h"
+#endif
phys_size_t fixed_sdram(void);
return 0;
}
+int board_early_init_r(void)
+{
+ const unsigned int flashbase = CONFIG_SYS_NAND_BASE;
+ const u8 flash_esel = 0;
+
+ /*
+ * Remap Boot flash to caching-inhibited
+ * so that flash can be erased properly.
+ */
+
+ /* Flush d-cache and invalidate i-cache of any FLASH data */
+ flush_dcache();
+ invalidate_icache();
+
+ /* invalidate existing TLB entry for flash */
+ disable_tlb(flash_esel);
+
+ set_tlb(1, flashbase, CONFIG_SYS_NAND_BASE, /* tlb, epn, rpn */
+ MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G, /* perms, wimge */
+ 0, flash_esel, /* ts, esel */
+ BOOKE_PAGESZ_64M, 1); /* tsize, iprot */
+
+ return 0;
+}
+
int checkboard (void)
{
printf ("Board: 8569 MDS\n");
local_bus_init(void)
{
volatile ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);
- volatile ccsr_lbc_t *lbc = (void *)(CONFIG_SYS_MPC85xx_LBC_ADDR);
+ volatile fsl_lbc_t *lbc = LBC_BASE_ADDR;
uint clkdiv;
uint lbc_hz;
console_assign(stdin, "eserial1");
printf("Switched to UART1 (initial log has been printed to "
"UART0).\n");
+
+ clrsetbits_be32(&gur->plppar1, PLPPAR1_UART0_BIT_MASK,
+ PLPPAR1_ESDHC_4BITS_VAL);
+ clrsetbits_be32(&gur->plpdir1, PLPDIR1_UART0_BIT_MASK,
+ PLPDIR1_ESDHC_4BITS_VAL);
bcsr6 |= BCSR6_SD_CARD_4BITS;
} else {
printf("should be disabled.\n");
break;
}
}
+
+ if (hwconfig_subarg_cmp("esdhc", "mode", "4-bits")) {
+ off = fdt_node_offset_by_compatible(blob, -1, "fsl,esdhc");
+ if (off < 0) {
+ printf("WARNING: could not find esdhc node\n");
+ return;
+ }
+ fdt_delprop(blob, off, "sdhci,1-bit-only");
+ }
}
#else
static inline void fdt_board_fixup_esdhc(void *blob, bd_t *bd) {}
static struct pci_controller pcie1_hose;
#endif /* CONFIG_PCIE1 */
-int first_free_busno = 0;
-
#ifdef CONFIG_PCI
-void
-pci_init_board(void)
+void pci_init_board(void)
{
- volatile ccsr_gur_t *gur;
- uint io_sel;
- uint host_agent;
-
- gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);
- io_sel = (gur->pordevsr & MPC85xx_PORDEVSR_IO_SEL) >> 19;
- host_agent = (gur->porbmsr & MPC85xx_PORBMSR_HA) >> 16;
-
-#ifdef CONFIG_PCIE1
-{
- volatile ccsr_fsl_pci_t *pci;
- struct pci_controller *hose;
- int pcie_ep;
- struct pci_region *r;
- int pcie_configured;
-
- pci = (ccsr_fsl_pci_t *) CONFIG_SYS_PCIE1_ADDR;
- hose = &pcie1_hose;
- pcie_ep = is_fsl_pci_agent(LAW_TRGT_IF_PCIE_1, host_agent);
- r = hose->regions;
- pcie_configured = is_fsl_pci_cfg(LAW_TRGT_IF_PCIE_1, io_sel);
-
- if (pcie_configured && !(gur->devdisr & MPC85xx_DEVDISR_PCIE)){
- printf ("\n PCIE connected to slot as %s (base address %x)",
- pcie_ep ? "End Point" : "Root Complex",
- (uint)pci);
-
- if (pci->pme_msg_det) {
- pci->pme_msg_det = 0xffffffff;
- debug (" with errors. Clearing. Now 0x%08x",
- pci->pme_msg_det);
- }
- printf ("\n");
-
- /* outbound memory */
- pci_set_region(r++,
- CONFIG_SYS_PCIE1_MEM_BUS,
- CONFIG_SYS_PCIE1_MEM_PHYS,
- CONFIG_SYS_PCIE1_MEM_SIZE,
- PCI_REGION_MEM);
+ volatile ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);
+ struct fsl_pci_info pci_info[1];
+ u32 devdisr, pordevsr, io_sel;
+ int first_free_busno = 0;
+ int num = 0;
- /* outbound io */
- pci_set_region(r++,
- CONFIG_SYS_PCIE1_IO_BUS,
- CONFIG_SYS_PCIE1_IO_PHYS,
- CONFIG_SYS_PCIE1_IO_SIZE,
- PCI_REGION_IO);
+ int pcie_ep, pcie_configured;
- hose->region_count = r - hose->regions;
+ devdisr = in_be32(&gur->devdisr);
+ pordevsr = in_be32(&gur->pordevsr);
+ io_sel = (pordevsr & MPC85xx_PORDEVSR_IO_SEL) >> 19;
- hose->first_busno=first_free_busno;
+ debug (" pci_init_board: devdisr=%x, io_sel=%x\n", devdisr, io_sel);
- fsl_pci_init(hose, (u32)&pci->cfg_addr, (u32)&pci->cfg_data);
- printf ("PCIE on bus %02x - %02x\n",
- hose->first_busno,hose->last_busno);
+#if defined(CONFIG_PQ_MDS_PIB)
+ pib_init();
+#endif
- first_free_busno=hose->last_busno+1;
+#ifdef CONFIG_PCIE1
+ pcie_configured = is_fsl_pci_cfg(LAW_TRGT_IF_PCIE_1, io_sel);
+ if (pcie_configured && !(devdisr & MPC85xx_DEVDISR_PCIE)){
+ SET_STD_PCIE_INFO(pci_info[num], 1);
+ pcie_ep = fsl_setup_hose(&pcie1_hose, pci_info[num].regs);
+ printf("PCIE1: connected to Slot as %s (base addr %lx)\n",
+ pcie_ep ? "Endpoint" : "Root Complex",
+ pci_info[num].regs);
+ first_free_busno = fsl_pci_init_port(&pci_info[num++],
+ &pcie1_hose, first_free_busno);
} else {
- printf (" PCIE: disabled\n");
+ printf("PCIE1: disabled\n");
}
-}
+
+ puts("\n");
#else
- gur->devdisr |= MPC85xx_DEVDISR_PCIE; /* disable */
+ setbits_be32(&gur->devdisr, MPC85xx_DEVDISR_PCIE); /* disable */
#endif
+
}
#endif /* CONFIG_PCI */
break;
}
- err = fdt_setprop_string(blob, nodeoff, "phy-connection-type",
- "rmii");
+ err = fdt_fixup_phy_connection(blob, nodeoff, RMII);
+
if (err < 0) {
printf("WARNING: could not set phy-connection-type "
"%s.\n", fdt_strerror(err));
#endif
ft_cpu_setup(blob, bd);
-#ifdef CONFIG_PCIE1
- ft_fsl_pci_setup(blob, "pci1", &pcie1_hose);
-#endif
+ FT_FSL_PCI_SETUP;
+
fdt_board_fixup_esdhc(blob, bd);
fdt_board_fixup_qe_uart(blob, bd);
fdt_board_fixup_qe_usb(blob, bd);
projects / karo-tx-uboot.git / blobdiff