* Patch by Robin Getz, 13 Oct 2004:

[karo-tx-uboot.git] / board / omap2420h4 / mem.c

diff --git a/board/omap2420h4/mem.c b/board/omap2420h4/mem.c
index 3ce38cc4d48078071d3b0d35744adbd50474c1c2..9ae595b3cac212f31ad057e878b223b65d4b8612 100644 (file)
--- a/board/omap2420h4/mem.c
+++ b/board/omap2420h4/mem.c
@@ -74,9 +74,9 @@ void prcm_init(void)
 
        if(running_in_sram()){
                /* If running fully from SRAM this is OK.  The Flash bus drops out for just a little.
-               * but then comes back.  If running from Flash this sequence kills you, thus you need
-               * to run it using CONFIG_PARTIAL_SRAM.
-               */
+               * but then comes back.  If running from Flash this sequence kills you, thus you need
+               * to run it using CONFIG_PARTIAL_SRAM.
+               */
                __raw_writel(MODE_BYPASS_FAST, CM_CLKEN_PLL); /* go to bypass, fast relock */
                wait_on_value(BIT0|BIT1, BIT0, CM_IDLEST_CKGEN, LDELAY); /* wait till in bypass */
                sdelay(1000);
@@ -172,14 +172,13 @@ void do_sdrc_init(u32 offset, u32 early)
        cpu = get_cpu_type();
 
        /* warning generated, though code generation is correct. this may bite later,
-         * but is ok for now. there is only so much C code you can do on stack only
-         * operation.
+        * but is ok for now. there is only so much C code you can do on stack only
+        * operation.
         */
        if (cpu == CPU_2422){
                sdata = (sdrc_data_t *)&sdrc_2422;
                pass_type = STACKED;
-       }
-       else{
+       } else{
                sdata = (sdrc_data_t *)&sdrc_2420;
                pass_type = IP_DDR;
        }
@@ -187,10 +186,10 @@ void do_sdrc_init(u32 offset, u32 early)
        __asm__ __volatile__("": : :"memory");  /* limit compiler scope */
 
        /* u-boot is compiled to run in DDR or SRAM at 8xxxxxxx or 4xxxxxxx.
-         * If we are running in flash prior to relocation and we use data
-         * here which is not pc relative we need to get the address correct.
-         * We need to find the current flash mapping to dress up the initial
-         * pointer load.  As long as this is const data we should be ok.
+        * If we are running in flash prior to relocation and we use data
+        * here which is not pc relative we need to get the address correct.
+        * We need to find the current flash mapping to dress up the initial
+        * pointer load.  As long as this is const data we should be ok.
         */
        if((early) && running_in_flash()){
                sdata = (sdrc_data_t *)(((u32)sdata & 0x0003FFFF) | get_gpmc0_base());
@@ -344,4 +343,3 @@ void gpmc_init(void)
        __raw_writel(H4_24XX_GPMC_CONFIG7_1, GPMC_CONFIG7_1); /* enable mapping */
        sdelay(2000);
 }
-