dm: exynos: dts: Adjust device tree files for U-Boot

[karo-tx-uboot.git] / common / usb_hub.c

diff --git a/common/usb_hub.c b/common/usb_hub.c
index 2add4b97920fefedbad4d2cd04b888d294992841..c416e5e0b31790e2bc7570fd113f7b52bb2a4502 100644 (file)
--- a/common/usb_hub.c
+++ b/common/usb_hub.c
@@ -209,9 +209,22 @@ int hub_port_reset(struct usb_device *dev, int port,
                      (portstatus & USB_PORT_STAT_CONNECTION) ? 1 : 0,
                      (portstatus & USB_PORT_STAT_ENABLE) ? 1 : 0);
 
-               if ((portchange & USB_PORT_STAT_C_CONNECTION) ||
-                   !(portstatus & USB_PORT_STAT_CONNECTION))
-                       return -1;
+               /*
+                * Perhaps we should check for the following here:
+                * - C_CONNECTION hasn't been set.
+                * - CONNECTION is still set.
+                *
+                * Doing so would ensure that the device is still connected
+                * to the bus, and hasn't been unplugged or replaced while the
+                * USB bus reset was going on.
+                *
+                * However, if we do that, then (at least) a San Disk Ultra
+                * USB 3.0 16GB device fails to reset on (at least) an NVIDIA
+                * Tegra Jetson TK1 board. For some reason, the device appears
+                * to briefly drop off the bus when this second bus reset is
+                * executed, yet if we retry this loop, it'll eventually come
+                * back after another reset or two.
+                */
 
                if (portstatus & USB_PORT_STAT_ENABLE)
                        break;