sandbox: Add architecture header files

[karo-tx-uboot.git] / doc / README.usb

diff --git a/doc/README.usb b/doc/README.usb
index a8a4058de122d6c068d9cb91b218bdc89919c0b8..c4df9cd0512d203988cd33d27a9248301d9c67a8 100644 (file)
--- a/doc/README.usb
+++ b/doc/README.usb
@@ -116,7 +116,7 @@ Bus 002 Device 010: ID 0b95:7720 ASIX Electronics Corp. AX88772
 If you look at drivers/usb/eth/asix.c you will see this line within the
 supported device list, so we know this adapter is supported.
 
-        { 0x0b95, 0x7720 },     /* Trendnet TU2-ET100 V3.0R */
+       { 0x0b95, 0x7720 },     /* Trendnet TU2-ET100 V3.0R */
 
 If your adapter is not listed there is a still a chance that it will
 work. Try looking up the manufacturer of the chip inside your adapter.
@@ -144,14 +144,13 @@ To enable USB Host Ethernet in U-Boot, your platform must of course
 support USB with CONFIG_CMD_USB enabled and working. You will need to
 add some config settings to your board header file:
 
-#define CONFIG_USB_HOST_ETHER   /* Enable USB Ethernet adapters */
-#define CONFIG_USB_ETHER_ASIX   /* Asix, or whatever driver(s) you want */
+#define CONFIG_USB_HOST_ETHER  /* Enable USB Ethernet adapters */
+#define CONFIG_USB_ETHER_ASIX  /* Asix, or whatever driver(s) you want */
 
 As with built-in networking, you will also want to enable some network
 commands, for example:
 
 #define CONFIG_CMD_NET
-#define CONFIG_NET_MULTI
 #define CONFIG_CMD_PING
 #define CONFIG_CMD_DHCP
 
@@ -168,9 +167,9 @@ You can also set the default IP address of your board and the server
 as well as the default file to load when a 'bootp' command is issued.
 All of these can be obtained from the bootp server if not set.
 
-#define CONFIG_IPADDR           10.0.0.2  (replace with your value)
-#define CONFIG_SERVERIP         10.0.0.1  (replace with your value)
-#define CONFIG_BOOTFILE         uImage
+#define CONFIG_IPADDR          10.0.0.2  (replace with your value)
+#define CONFIG_SERVERIP                10.0.0.1  (replace with your value)
+#define CONFIG_BOOTFILE                uImage
 
 
 The 'usb start' command should identify the adapter something like this:
@@ -200,9 +199,9 @@ TFTP from server 172.22.72.144; our IP address is 172.22.73.81
 Filename '/tftpboot/uImage-sjg-seaboard-261347'.
 Load address: 0x40c000
 Loading: #################################################################
-         #################################################################
-         #################################################################
-         ################################################
+        #################################################################
+        #################################################################
+        ################################################
 done
 Bytes transferred = 3557464 (364858 hex)
 CrOS>