dm: Add Kconfig options for driver model SPL support

[karo-tx-uboot.git] / drivers / core / Kconfig

diff --git a/drivers/core/Kconfig b/drivers/core/Kconfig
index d2799dc861ff5a661ff6717c985285f263ebd1e9..f0d611007af98921f4ca85cb2f770faf560e74ad 100644 (file)
--- a/drivers/core/Kconfig
+++ b/drivers/core/Kconfig
@@ -2,5 +2,51 @@ config DM
        bool "Enable Driver Model"
        depends on !SPL_BUILD
        help
-         This config option enables Driver Model.
-         To use legacy drivers, say N.
+         This config option enables Driver Model. This brings in the core
+         support, including scanning of platform data on start-up. If
+         CONFIG_OF_CONTROL is enabled, the device tree will be scanned also
+         when available.
+
+config SPL_DM
+       bool "Enable Driver Model for SPL"
+       depends on DM && SPL
+       help
+         Enable driver model in SPL. You will need to provide a
+         suitable malloc() implementation. If you are not using the
+         full malloc() enabled by CONFIG_SYS_SPL_MALLOC_START,
+         consider using CONFIG_SYS_MALLOC_SIMPLE. In that case you
+         must provide CONFIG_SYS_MALLOC_F_LEN to set the size.
+         In most cases driver model will only allocate a few uclasses
+         and devices in SPL, so 1KB should be enable. See
+         CONFIG_SYS_MALLOC_F_LEN for more details on how to enable it.
+
+config DM_WARN
+       bool "Enable warnings in driver model"
+       help
+         The dm_warn() function can use up quite a bit of space for its
+         strings. By default this is disabled for SPL builds to save space.
+         This will cause dm_warn() to be compiled out - it will do nothing
+         when called.
+       depends on DM
+       default y if !SPL_BUILD
+       default n if SPL_BUILD
+
+config DM_DEVICE_REMOVE
+       bool "Support device removal"
+       help
+         We can save some code space by dropping support for removing a
+         device. This is not normally required in SPL, so by default this
+         option is disabled for SPL.
+       depends on DM
+       default y if !SPL_BUILD
+       default n if SPL_BUILD
+
+config DM_STDIO
+       bool "Support stdio registration"
+       help
+         Normally serial drivers register with stdio so that they can be used
+         as normal output devices. In SPL we don't normally use stdio, so
+         we can omit this feature.
+       depends on DM
+       default y if !SPL_BUILD
+       default n if SPL_BUILD