* SPI flash internal definitions
*
* Copyright (C) 2008 Atmel Corporation
+ * Copyright (C) 2013 Jagannadha Sutradharudu Teki, Xilinx Inc.
+ *
+ * Licensed under the GPL-2 or later.
*/
-/* Common parameters -- kind of high, but they should only occur when there
- * is a problem (and well your system already is broken), so err on the side
- * of caution in case we're dealing with slower SPI buses and/or processors.
- */
-#define SPI_FLASH_PROG_TIMEOUT (2 * CONFIG_SYS_HZ)
-#define SPI_FLASH_PAGE_ERASE_TIMEOUT (5 * CONFIG_SYS_HZ)
-#define SPI_FLASH_SECTOR_ERASE_TIMEOUT (10 * CONFIG_SYS_HZ)
+#ifndef _SPI_FLASH_INTERNAL_H_
+#define _SPI_FLASH_INTERNAL_H_
-/* Common commands */
-#define CMD_READ_ID 0x9f
+#define SPI_FLASH_16MB_BOUN 0x1000000
-#define CMD_READ_ARRAY_SLOW 0x03
-#define CMD_READ_ARRAY_FAST 0x0b
+/* SECT flags */
+#define SECT_4K (1 << 1)
+#define SECT_32K (1 << 2)
+#define E_FSR (1 << 3)
+
+/* Erase commands */
+#define CMD_ERASE_4K 0x20
+#define CMD_ERASE_32K 0x52
+#define CMD_ERASE_CHIP 0xc7
+#define CMD_ERASE_64K 0xd8
+/* Write commands */
#define CMD_WRITE_STATUS 0x01
#define CMD_PAGE_PROGRAM 0x02
#define CMD_WRITE_DISABLE 0x04
#define CMD_READ_STATUS 0x05
#define CMD_WRITE_ENABLE 0x06
+#define CMD_READ_CONFIG 0x35
+#define CMD_FLAG_STATUS 0x70
+
+/* Read commands */
+#define CMD_READ_ARRAY_SLOW 0x03
+#define CMD_READ_ARRAY_FAST 0x0b
+#define CMD_READ_ID 0x9f
+
+/* Bank addr access commands */
+#ifdef CONFIG_SPI_FLASH_BAR
+# define CMD_BANKADDR_BRWR 0x17
+# define CMD_BANKADDR_BRRD 0x16
+# define CMD_EXTNADDR_WREAR 0xC5
+# define CMD_EXTNADDR_RDEAR 0xC8
+#endif
/* Common status */
#define STATUS_WIP 0x01
+#define STATUS_PEC 0x80
+
+/* Flash timeout values */
+#define SPI_FLASH_PROG_TIMEOUT (2 * CONFIG_SYS_HZ)
+#define SPI_FLASH_PAGE_ERASE_TIMEOUT (5 * CONFIG_SYS_HZ)
+#define SPI_FLASH_SECTOR_ERASE_TIMEOUT (10 * CONFIG_SYS_HZ)
+
+/* SST specific */
+#ifdef CONFIG_SPI_FLASH_SST
+# define SST_WP 0x01 /* Supports AAI word program */
+# define CMD_SST_BP 0x02 /* Byte Program */
+# define CMD_SST_AAI_WP 0xAD /* Auto Address Incr Word Program */
+
+int sst_write_wp(struct spi_flash *flash, u32 offset, size_t len,
+ const void *buf);
+#endif
/* Send a single-byte command to the device and read the response */
int spi_flash_cmd(struct spi_slave *spi, u8 cmd, void *response, size_t len);
int spi_flash_cmd_read(struct spi_slave *spi, const u8 *cmd,
size_t cmd_len, void *data, size_t data_len);
-int spi_flash_cmd_read_fast(struct spi_flash *flash, u32 offset,
- size_t len, void *data);
-
/*
* Send a multi-byte command to the device followed by (optional)
* data. Used for programming the flash array, etc.
int spi_flash_cmd_write(struct spi_slave *spi, const u8 *cmd, size_t cmd_len,
const void *data, size_t data_len);
-/*
- * Write the requested data out breaking it up into multiple write
- * commands as needed per the write size.
- */
-int spi_flash_cmd_write_multi(struct spi_flash *flash, u32 offset,
- size_t len, const void *buf);
-/*
- * Enable writing on the SPI flash.
- */
+/* Flash erase(sectors) operation, support all possible erase commands */
+int spi_flash_cmd_erase_ops(struct spi_flash *flash, u32 offset, size_t len);
+
+/* Program the status register */
+int spi_flash_cmd_write_status(struct spi_flash *flash, u8 sr);
+
+/* Set quad enbale bit */
+int spi_flash_set_qeb(struct spi_flash *flash);
+
+/* Enable writing on the SPI flash */
static inline int spi_flash_cmd_write_enable(struct spi_flash *flash)
{
return spi_flash_cmd(flash->spi, CMD_WRITE_ENABLE, NULL, 0);
}
-/*
- * Disable writing on the SPI flash.
- */
+/* Disable writing on the SPI flash */
static inline int spi_flash_cmd_write_disable(struct spi_flash *flash)
{
return spi_flash_cmd(flash->spi, CMD_WRITE_DISABLE, NULL, 0);
}
+/*
+ * Send the read status command to the device and wait for the wip
+ * (write-in-progress) bit to clear itself.
+ */
+int spi_flash_cmd_wait_ready(struct spi_flash *flash, unsigned long timeout);
+
+/*
+ * Used for spi_flash write operation
+ * - SPI claim
+ * - spi_flash_cmd_write_enable
+ * - spi_flash_cmd_write
+ * - spi_flash_cmd_wait_ready
+ * - SPI release
+ */
+int spi_flash_write_common(struct spi_flash *flash, const u8 *cmd,
+ size_t cmd_len, const void *buf, size_t buf_len);
+
+/*
+ * Flash write operation, support all possible write commands.
+ * Write the requested data out breaking it up into multiple write
+ * commands as needed per the write size.
+ */
+int spi_flash_cmd_write_ops(struct spi_flash *flash, u32 offset,
+ size_t len, const void *buf);
+
/*
* Same as spi_flash_cmd_read() except it also claims/releases the SPI
* bus. Used as common part of the ->read() operation.
int spi_flash_read_common(struct spi_flash *flash, const u8 *cmd,
size_t cmd_len, void *data, size_t data_len);
-/* Send a command to the device and wait for some bit to clear itself. */
-int spi_flash_cmd_poll_bit(struct spi_flash *flash, unsigned long timeout,
- u8 cmd, u8 poll_bit);
-
-/*
- * Send the read status command to the device and wait for the wip
- * (write-in-progress) bit to clear itself.
- */
-int spi_flash_cmd_wait_ready(struct spi_flash *flash, unsigned long timeout);
+/* Flash read operation, support all possible read commands */
+int spi_flash_cmd_read_ops(struct spi_flash *flash, u32 offset,
+ size_t len, void *data);
-/* Erase sectors. */
-int spi_flash_cmd_erase(struct spi_flash *flash, u8 erase_cmd,
- u32 offset, size_t len);
-
-/* Manufacturer-specific probe functions */
-struct spi_flash *spi_flash_probe_spansion(struct spi_slave *spi, u8 *idcode);
-struct spi_flash *spi_flash_probe_atmel(struct spi_slave *spi, u8 *idcode);
-struct spi_flash *spi_flash_probe_eon(struct spi_slave *spi, u8 *idcode);
-struct spi_flash *spi_flash_probe_macronix(struct spi_slave *spi, u8 *idcode);
-struct spi_flash *spi_flash_probe_sst(struct spi_slave *spi, u8 *idcode);
-struct spi_flash *spi_flash_probe_stmicro(struct spi_slave *spi, u8 *idcode);
-struct spi_flash *spi_flash_probe_winbond(struct spi_slave *spi, u8 *idcode);
-struct spi_flash *spi_fram_probe_ramtron(struct spi_slave *spi, u8 *idcode);
+#endif /* _SPI_FLASH_INTERNAL_H_ */
projects / karo-tx-uboot.git / blobdiff