* Copyright (C) 2008, 2011 Renesas Solutions Corp.
* Copyright (c) 2008, 2011 Nobuhiro Iwamatsu
* Copyright (c) 2007 Carlos Munoz <carlos@kenati.com>
+ * Copyright (C) 2013 Renesas Electronics Corporation
*
- * This program is free software; you can redistribute it and/or modify
- * it under the terms of the GNU General Public License as published by
- * the Free Software Foundation; either version 2 of the License, or
- * (at your option) any later version.
- *
- * This program is distributed in the hope that it will be useful,
- * but WITHOUT ANY WARRANTY; without even the implied warranty of
- * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
- * GNU General Public License for more details.
- *
- * You should have received a copy of the GNU General Public License
- * along with this program; if not, write to the Free Software
- * Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
+ * SPDX-License-Identifier: GPL-2.0+
*/
#include <config.h>
#ifndef CONFIG_SH_ETHER_PHY_ADDR
# error "Please define CONFIG_SH_ETHER_PHY_ADDR"
#endif
-#ifdef CONFIG_SH_ETHER_CACHE_WRITEBACK
-#define flush_cache_wback(addr, len) \
- dcache_wback_range((u32)addr, (u32)(addr + len - 1))
+
+#if defined(CONFIG_SH_ETHER_CACHE_WRITEBACK) && !defined(CONFIG_SYS_DCACHE_OFF)
+#define flush_cache_wback(addr, len) \
+ flush_dcache_range((u32)addr, (u32)(addr + len - 1))
#else
#define flush_cache_wback(...)
#endif
+#if defined(CONFIG_SH_ETHER_CACHE_INVALIDATE) && defined(CONFIG_ARM)
+#define invalidate_cache(addr, len) \
+ { \
+ u32 line_size = CONFIG_SH_ETHER_ALIGNE_SIZE; \
+ u32 start, end; \
+ \
+ start = (u32)addr; \
+ end = start + len; \
+ start &= ~(line_size - 1); \
+ end = ((end + line_size - 1) & ~(line_size - 1)); \
+ \
+ invalidate_dcache_range(start, end); \
+ }
+#else
+#define invalidate_cache(...)
+#endif
+
#define TIMEOUT_CNT 1000
int sh_eth_send(struct eth_device *dev, void *packet, int len)
/* packet must be a 4 byte boundary */
if ((int)packet & 3) {
- printf(SHETHER_NAME ": %s: packet not 4 byte alligned\n", __func__);
+ printf(SHETHER_NAME ": %s: packet not 4 byte alligned\n"
+ , __func__);
ret = -EFAULT;
goto err;
}
/* Wait until packet is transmitted */
timeout = TIMEOUT_CNT;
- while (port_info->tx_desc_cur->td0 & TD_TACT && timeout--)
+ do {
+ invalidate_cache(port_info->tx_desc_cur,
+ sizeof(struct tx_desc_s));
udelay(100);
+ } while (port_info->tx_desc_cur->td0 & TD_TACT && timeout--);
if (timeout < 0) {
printf(SHETHER_NAME ": transmit timeout\n");
uchar *packet;
/* Check if the rx descriptor is ready */
+ invalidate_cache(port_info->rx_desc_cur, sizeof(struct rx_desc_s));
if (!(port_info->rx_desc_cur->rd0 & RD_RACT)) {
/* Check for errors */
if (!(port_info->rx_desc_cur->rd0 & RD_RFE)) {
len = port_info->rx_desc_cur->rd1 & 0xffff;
packet = (uchar *)
ADDR_TO_P2(port_info->rx_desc_cur->rd2);
+ invalidate_cache(packet, len);
NetReceive(packet, len);
}
port_info->rx_desc_cur->rd0 = RD_RACT | RD_RDLE;
else
port_info->rx_desc_cur->rd0 = RD_RACT;
-
/* Point to the next descriptor */
port_info->rx_desc_cur++;
if (port_info->rx_desc_cur >=
static int sh_eth_reset(struct sh_eth_dev *eth)
{
-#if defined(SH_ETH_TYPE_GETHER)
+#if defined(SH_ETH_TYPE_GETHER) || defined(SH_ETH_TYPE_RZ)
int ret = 0, i;
/* Start e-dmac transmitter and receiver */
/* Perform a software reset and wait for it to complete */
sh_eth_write(eth, EDMR_SRST, EDMR);
- for (i = 0; i < TIMEOUT_CNT ; i++) {
+ for (i = 0; i < TIMEOUT_CNT; i++) {
if (!(sh_eth_read(eth, EDMR) & EDMR_SRST))
break;
udelay(1000);
/* Point the controller to the tx descriptor list. Must use physical
addresses */
sh_eth_write(eth, ADDR_TO_PHY(port_info->tx_desc_base), TDLAR);
-#if defined(SH_ETH_TYPE_GETHER)
+#if defined(SH_ETH_TYPE_GETHER) || defined(SH_ETH_TYPE_RZ)
sh_eth_write(eth, ADDR_TO_PHY(port_info->tx_desc_base), TDFAR);
sh_eth_write(eth, ADDR_TO_PHY(cur_tx_desc), TDFXR);
sh_eth_write(eth, 0x01, TDFFR);/* Last discriptor bit */
* Allocate rx data buffers. They must be 32 bytes aligned and in
* P2 area
*/
- port_info->rx_buf_malloc = malloc(NUM_RX_DESC * MAX_BUF_SIZE + 31);
+ port_info->rx_buf_malloc = malloc(
+ NUM_RX_DESC * MAX_BUF_SIZE + RX_BUF_ALIGNE_SIZE - 1);
if (!port_info->rx_buf_malloc) {
printf(SHETHER_NAME ": malloc failed\n");
ret = -ENOMEM;
goto err_buf_malloc;
}
- tmp_addr = (u32)(((int)port_info->rx_buf_malloc + (32 - 1)) &
- ~(32 - 1));
+ tmp_addr = (u32)(((int)port_info->rx_buf_malloc
+ + (RX_BUF_ALIGNE_SIZE - 1)) &
+ ~(RX_BUF_ALIGNE_SIZE - 1));
port_info->rx_buf_base = (u8 *)ADDR_TO_P2(tmp_addr);
/* Initialize all descriptors */
/* Point the controller to the rx descriptor list */
sh_eth_write(eth, ADDR_TO_PHY(port_info->rx_desc_base), RDLAR);
-#if defined(SH_ETH_TYPE_GETHER)
+#if defined(SH_ETH_TYPE_GETHER) || defined(SH_ETH_TYPE_RZ)
sh_eth_write(eth, ADDR_TO_PHY(port_info->rx_desc_base), RDFAR);
sh_eth_write(eth, ADDR_TO_PHY(cur_rx_desc), RDFXR);
sh_eth_write(eth, RDFFR_RDLF, RDFFR);
struct phy_device *phy;
/* Configure e-dmac registers */
- sh_eth_write(eth, (sh_eth_read(eth, EDMR) & ~EMDR_DESC_R) | EDMR_EL,
- EDMR);
+ sh_eth_write(eth, (sh_eth_read(eth, EDMR) & ~EMDR_DESC_R) |
+ (EMDR_DESC | EDMR_EL), EDMR);
+
sh_eth_write(eth, 0, EESIPR);
sh_eth_write(eth, 0, TRSCER);
sh_eth_write(eth, 0, TFTR);
sh_eth_write(eth, (FIFO_SIZE_T | FIFO_SIZE_R), FDR);
sh_eth_write(eth, RMCR_RST, RMCR);
-#if defined(SH_ETH_TYPE_GETHER)
+#if defined(SH_ETH_TYPE_GETHER) || defined(SH_ETH_TYPE_RZ)
sh_eth_write(eth, 0, RPADIR);
#endif
sh_eth_write(eth, (FIFO_F_D_RFF | FIFO_F_D_RFD), FCFTR);
sh_eth_write(eth, RFLR_RFL_MIN, RFLR);
#if defined(SH_ETH_TYPE_GETHER)
sh_eth_write(eth, 0, PIPR);
+#endif
+#if defined(SH_ETH_TYPE_GETHER) || defined(SH_ETH_TYPE_RZ)
sh_eth_write(eth, APR_AP, APR);
sh_eth_write(eth, MPR_MP, MPR);
sh_eth_write(eth, TPAUSER_TPAUSE, TPAUSER);
#endif
-#if defined(CONFIG_CPU_SH7734)
+#if defined(CONFIG_CPU_SH7734) || defined(CONFIG_R8A7740)
sh_eth_write(eth, CONFIG_SH_ETHER_SH7734_MII, RMII_MII);
+#elif defined(CONFIG_R8A7790) || defined(CONFIG_R8A7791)
+ sh_eth_write(eth, sh_eth_read(eth, RMIIMR) | 0x1, RMIIMR);
#endif
/* Configure phy */
ret = sh_eth_phy_config(eth);
printf(SHETHER_NAME ": 100Base/");
#if defined(SH_ETH_TYPE_GETHER)
sh_eth_write(eth, GECMR_100B, GECMR);
-#elif defined(CONFIG_CPU_SH7757)
+#elif defined(CONFIG_CPU_SH7757) || defined(CONFIG_CPU_SH7752)
sh_eth_write(eth, 1, RTRATE);
-#elif defined(CONFIG_CPU_SH7724)
+#elif defined(CONFIG_CPU_SH7724) || defined(CONFIG_R8A7790) || \
+ defined(CONFIG_R8A7791)
val = ECMR_RTM;
#endif
} else if (phy->speed == 10) {
printf(SHETHER_NAME ": 10Base/");
#if defined(SH_ETH_TYPE_GETHER)
sh_eth_write(eth, GECMR_10B, GECMR);
-#elif defined(CONFIG_CPU_SH7757)
+#elif defined(CONFIG_CPU_SH7757) || defined(CONFIG_CPU_SH7752)
sh_eth_write(eth, 0, RTRATE);
#endif
}
int sh_eth_initialize(bd_t *bd)
{
- int ret = 0;
+ int ret = 0;
struct sh_eth_dev *eth = NULL;
- struct eth_device *dev = NULL;
+ struct eth_device *dev = NULL;
- eth = (struct sh_eth_dev *)malloc(sizeof(struct sh_eth_dev));
+ eth = (struct sh_eth_dev *)malloc(sizeof(struct sh_eth_dev));
if (!eth) {
printf(SHETHER_NAME ": %s: malloc failed\n", __func__);
ret = -ENOMEM;
goto err;
}
- dev = (struct eth_device *)malloc(sizeof(struct eth_device));
+ dev = (struct eth_device *)malloc(sizeof(struct eth_device));
if (!dev) {
printf(SHETHER_NAME ": %s: malloc failed\n", __func__);
ret = -ENOMEM;
goto err;
}
- memset(dev, 0, sizeof(struct eth_device));
- memset(eth, 0, sizeof(struct sh_eth_dev));
+ memset(dev, 0, sizeof(struct eth_device));
+ memset(eth, 0, sizeof(struct sh_eth_dev));
eth->port = CONFIG_SH_ETHER_USE_PORT;
eth->port_info[eth->port].phy_addr = CONFIG_SH_ETHER_PHY_ADDR;
- dev->priv = (void *)eth;
- dev->iobase = 0;
- dev->init = sh_eth_init;
- dev->halt = sh_eth_halt;
- dev->send = sh_eth_send;
- dev->recv = sh_eth_recv;
- eth->port_info[eth->port].dev = dev;
+ dev->priv = (void *)eth;
+ dev->iobase = 0;
+ dev->init = sh_eth_init;
+ dev->halt = sh_eth_halt;
+ dev->send = sh_eth_send;
+ dev->recv = sh_eth_recv;
+ eth->port_info[eth->port].dev = dev;
sprintf(dev->name, SHETHER_NAME);
- /* Register Device to EtherNet subsystem */
- eth_register(dev);
+ /* Register Device to EtherNet subsystem */
+ eth_register(dev);
bb_miiphy_buses[0].priv = eth;
miiphy_register(dev->name, bb_miiphy_read, bb_miiphy_write);
projects / karo-tx-uboot.git / blobdiff