unsigned long bi_flashoffset; /* reserved area for startup monitor */
unsigned long bi_sramstart; /* start of SRAM memory */
unsigned long bi_sramsize; /* size of SRAM memory */
+ unsigned long bi_mbar_base; /* base of internal registers */
unsigned long bi_bootflags; /* boot / reboot flag (for LynxOS) */
- unsigned long bi_boot_params; /* where this board expects params */
+ unsigned long bi_boot_params; /* where this board expects params */
unsigned long bi_ip_addr; /* IP Address */
- unsigned char bi_enetaddr[6]; /* Ethernet adress */
+ unsigned char bi_enetaddr[6]; /* Ethernet adress */
unsigned short bi_ethspeed; /* Ethernet speed in Mbps */
unsigned long bi_intfreq; /* Internal Freq, in MHz */
unsigned long bi_busfreq; /* Bus Freq, in MHz */
} bd_t;
#endif /* __ASSEMBLY__ */
-/* The following data structure is placed in DPRAM to allow for a
- * minimum set of global variables during system initialization
- * (until we have set up the memory controller so that we can use
- * RAM).
- *
- * Keep it *SMALL* and remember to set CFG_INIT_DATA_SIZE > sizeof(init_data_t)
- */
-typedef struct init_data {
- unsigned long cpu_clk; /* VCOOUT = CPU clock in Hz! */
- unsigned long env_addr; /* Address of Environment struct */
- unsigned long env_valid; /* Checksum of Environment valid? */
- unsigned long relocated; /* Relocat. offset when running in RAM */
- unsigned long have_console; /* serial_init() was called */
-#ifdef CONFIG_LCD
- unsigned long lcd_base; /* Base address of LCD frambuffer mem */
-#endif
-} init_data_t;
+
#endif /* __U_BOOT_H__ */