at91sam9260ek: move board id setup to config header

[karo-tx-uboot.git] / include / configs / SPD823TS.h

diff --git a/include/configs/SPD823TS.h b/include/configs/SPD823TS.h
index b132a780735b1420d07222d5939fa912600132b7..72ea217e54a0c4ddcfa1fa00bc7fd52a021b4764 100644 (file)
--- a/include/configs/SPD823TS.h
+++ b/include/configs/SPD823TS.h
@@ -121,8 +121,6 @@
 
 #define        CONFIG_SYS_HZ           1000            /* decrementer freq: 1 ms ticks */
 
-#define CONFIG_SYS_BAUDRATE_TABLE      { 9600, 19200, 38400, 57600, 115200 }
-
 /*
  * Low Level Configuration Settings
  * (address mappings, register initial values, etc.)
@@ -137,9 +135,8 @@
  * Definitions for initial stack pointer and data area (in DPRAM)
  */
 #define CONFIG_SYS_INIT_RAM_ADDR       CONFIG_SYS_IMMR
-#define CONFIG_SYS_INIT_RAM_END        0x2F00  /* End of used area in DPRAM    */
-#define CONFIG_SYS_GBL_DATA_SIZE       64  /* size in bytes reserved for initial data */
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define CONFIG_SYS_INIT_RAM_SIZE       0x2F00  /* Size of used area in DPRAM   */
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_OFFSET      CONFIG_SYS_GBL_DATA_OFFSET
 
 /*-----------------------------------------------------------------------
@@ -306,6 +303,8 @@
  * IDE/ATA stuff
  *-----------------------------------------------------------------------
  */
+#define CONFIG_IDE_PREINIT     1       /* Use preinit IDE hook */
+#define CONFIG_IDE_INIT_POSTRESET      1       /* Use postreset IDE hook */
 #define CONFIG_IDE_8xx_DIRECT  1       /* PCMCIA interface required    */
 #define CONFIG_IDE_LED         1       /* LED   for ide supported      */
 #define CONFIG_IDE_RESET       1       /* reset for ide supported      */