at91sam9260ek: move board id setup to config header

[karo-tx-uboot.git] / include / configs / SXNI855T.h

diff --git a/include/configs/SXNI855T.h b/include/configs/SXNI855T.h
index f3991532e6d54e91332a1a41522cf88743601364..b7fbe5e153a011d6f7f0b7b75d71b6fcec1082e8 100644 (file)
--- a/include/configs/SXNI855T.h
+++ b/include/configs/SXNI855T.h
@@ -188,8 +188,6 @@
 
 #define        CONFIG_SYS_HZ           1000            /* decrementer freq: 1 ms ticks */
 
-#define CONFIG_SYS_BAUDRATE_TABLE      { 9600, 19200, 38400, 57600, 115200 }
-
 /*
  * Low Level Configuration Settings
  * (address mappings, register initial values, etc.)
@@ -205,9 +203,8 @@
  * Definitions for initial stack pointer and data area (in DPRAM)
  */
 #define CONFIG_SYS_INIT_RAM_ADDR       CONFIG_SYS_IMMR
-#define        CONFIG_SYS_INIT_RAM_END 0x2F00  /* End of used area in DPRAM    */
-#define        CONFIG_SYS_GBL_DATA_SIZE        64  /* size in bytes reserved for initial data */
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define        CONFIG_SYS_INIT_RAM_SIZE        0x2F00  /* Size of used area in DPRAM   */
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define        CONFIG_SYS_INIT_SP_OFFSET       CONFIG_SYS_GBL_DATA_OFFSET
 
 /*-----------------------------------------------------------------------
@@ -374,13 +371,6 @@
 #define DUART_BR5_VALUE ((CONFIG_SYS_DUARTA_BASE & BR_BA_MSK ) | DUART_BR_VALUE)
 #define DUART_BR6_VALUE ((CONFIG_SYS_DUARTB_BASE & BR_BA_MSK ) | DUART_BR_VALUE)
 
-/**********************************************************
- *
- * Boot Flags
- */
-#define        BOOTFLAG_COLD   0x01            /* Normal Power-On: Boot from FLASH     */
-#define BOOTFLAG_WARM  0x02            /* Software reboot                      */
-
 #define CONFIG_RESET_ON_PANIC          /* reset if system panic() */
 
 #define CONFIG_ENV_IS_IN_FLASH