at91sam9260ek: move board id setup to config header

[karo-tx-uboot.git] / include / configs / TQM860L.h

diff --git a/include/configs/TQM860L.h b/include/configs/TQM860L.h
index b67cdcd8918bb1fdee663a11e63679a5285cca07..81e1b91ee7a45759a00ce08cb789f03689e6609d 100644 (file)
--- a/include/configs/TQM860L.h
+++ b/include/configs/TQM860L.h
@@ -36,10 +36,11 @@
 #define CONFIG_MPC860          1       /* This is a MPC860 CPU         */
 #define CONFIG_TQM860L         1       /* ...on a TQM8xxL module       */
 
-#define        CONFIG_8xx_CONS_SMC1    1       /* Console is on SMC1           */
-#undef CONFIG_8xx_CONS_SMC2
-#undef CONFIG_8xx_CONS_NONE
+#define        CONFIG_SYS_TEXT_BASE    0x40000000
 
+#define        CONFIG_8xx_CONS_SMC1    1       /* Console is on SMC1           */
+#define CONFIG_SYS_SMC_RXBUFLEN        128
+#define CONFIG_SYS_MAXIDLE     10
 #define CONFIG_BAUDRATE                115200  /* console baudrate = 115kbps   */
 
 #define        CONFIG_BOOTCOUNT_LIMIT
@@ -116,6 +117,7 @@
 #define CONFIG_CMD_DATE
 #define CONFIG_CMD_DHCP
 #define CONFIG_CMD_ELF
+#define CONFIG_CMD_EXT2
 #define CONFIG_CMD_IDE
 #define CONFIG_CMD_JFFS2
 #define CONFIG_CMD_NFS
@@ -132,9 +134,6 @@
 
 #define CONFIG_CMDLINE_EDITING 1       /* add command line history     */
 #define CONFIG_SYS_HUSH_PARSER         1       /* Use the HUSH parser          */
-#ifdef CONFIG_SYS_HUSH_PARSER
-#define        CONFIG_SYS_PROMPT_HUSH_PS2      "> "
-#endif
 
 #if defined(CONFIG_CMD_KGDB)
 #define        CONFIG_SYS_CBSIZE               1024    /* Console I/O Buffer Size      */
@@ -152,8 +151,6 @@
 
 #define        CONFIG_SYS_HZ                   1000    /* decrementer freq: 1 ms ticks */
 
-#define CONFIG_SYS_BAUDRATE_TABLE      { 9600, 19200, 38400, 57600, 115200 }
-
 /*
  * Low Level Configuration Settings
  * (address mappings, register initial values, etc.)
@@ -168,9 +165,8 @@
  * Definitions for initial stack pointer and data area (in DPRAM)
  */
 #define CONFIG_SYS_INIT_RAM_ADDR       CONFIG_SYS_IMMR
-#define        CONFIG_SYS_INIT_RAM_END 0x2F00  /* End of used area in DPRAM    */
-#define        CONFIG_SYS_GBL_DATA_SIZE        64  /* size in bytes reserved for initial data */
-#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_END - CONFIG_SYS_GBL_DATA_SIZE)
+#define        CONFIG_SYS_INIT_RAM_SIZE        0x2F00  /* Size of used area in DPRAM   */
+#define CONFIG_SYS_GBL_DATA_OFFSET     (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define        CONFIG_SYS_INIT_SP_OFFSET       CONFIG_SYS_GBL_DATA_OFFSET
 
 /*-----------------------------------------------------------------------
@@ -219,7 +215,9 @@
 /*-----------------------------------------------------------------------
  * Dynamic MTD partition support
  */
-#define CONFIG_JFFS2_CMDLINE
+#define CONFIG_CMD_MTDPARTS
+#define CONFIG_MTD_DEVICE              /* needed for mtdparts commands */
+#define CONFIG_FLASH_CFI_MTD
 #define MTDIDS_DEFAULT         "nor0=TQM8xxL-0"
 
 #define MTDPARTS_DEFAULT       "mtdparts=TQM8xxL-0:256k(u-boot),"      \
@@ -325,6 +323,7 @@
  *-----------------------------------------------------------------------
  */
 
+#define CONFIG_IDE_PREINIT     1       /* Use preinit IDE hook */
 #define        CONFIG_IDE_8xx_PCCARD   1       /* Use IDE with PC Card Adapter */
 
 #undef CONFIG_IDE_8xx_DIRECT           /* Direct IDE    not supported  */
@@ -467,17 +466,13 @@
                         MAMR_AMA_TYPE_1 | MAMR_DSA_1_CYCL | MAMR_G0CLA_A10 |   \
                         MAMR_RLFA_1X    | MAMR_WLFA_1X    | MAMR_TLFA_4X)
 
-
-/*
- * Internal Definitions
- *
- * Boot Flags
- */
-#define        BOOTFLAG_COLD   0x01            /* Normal Power-On: Boot from FLASH     */
-#define BOOTFLAG_WARM  0x02            /* Software reboot                      */
-
 #define CONFIG_SCC1_ENET
 #define CONFIG_FEC_ENET
-#define CONFIG_ETHPRIME                "SCC ETHERNET"
+#define CONFIG_ETHPRIME                "SCC"
+
+/* pass open firmware flat tree */
+#define CONFIG_OF_LIBFDT       1
+#define CONFIG_OF_BOARD_SETUP  1
+#define CONFIG_HWCONFIG                1
 
 #endif /* __CONFIG_H */