*/
#define CONFIG_BOOTCOMMAND "run net_nfs"
#define CONFIG_BOOTDELAY 5
+#define CONFIG_MCFUART
+#define CONFIG_SYS_UART_PORT (0)
#define CONFIG_BAUDRATE 19200
-#define CFG_BAUDRATE_TABLE { 9600 , 19200 , 38400 , 57600, 115200 }
#define CONFIG_ETHADDR 00:06:3b:01:41:55
#define CONFIG_ETHPRIME
#define CONFIG_IPADDR 192.168.30.1
#define CONFIG_SERVERIP 192.168.1.1
-#define CONFIG_ROOTPATH
+#define CONFIG_ROOTPATH ""
#define CONFIG_GATEWAYIP 192.168.1.1
#define CONFIG_NETMASK 255.255.0.0
#define CONFIG_HOSTNAME idmr
-#define CONFIG_BOOTFILE /tftpboot/idmr/uImage
-#define CONFIG_PREBOOT "echo;echo Type \"run flash_nfs\" to mount root " \
+#define CONFIG_BOOTFILE "/tftpboot/idmr/uImage"
+#define CONFIG_PREBOOT "echo;echo Type \\\"run flash_nfs\\\" to mount root " \
"filesystem over NFS; echo"
+#define CONFIG_MCFTMR
+
#define CONFIG_EXTRA_ENV_SETTINGS \
"netdev=eth0\0" \
"ramargs=setenv bootargs root=/dev/ram rw\0" \
"net_nfs=tftp 200000 $(bootfile);run nfsargs addip;bootm\0" \
"nfsargs=setenv bootargs root=/dev/nfs rw " \
"nfsroot=$(serverip):$(rootpath)\0" \
- "ethact=FEC ETHERNET\0" \
+ "ethact=FEC\0 " \
"update=prot off ff800000 ff81ffff; era ff800000 ff81ffff; " \
"cp.b 200000 ff800000 $(filesize);" \
"prot on ff800000 ff81ffff\0" \
""
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+
+
/*
* Command line configuration.
*/
* Configuration for environment, which occupies third sector in flash.
*/
#ifndef CONFIG_MONITOR_IS_IN_RAM
-#define CFG_ENV_ADDR 0xff820000
-#define CFG_ENV_SECT_SIZE 0x10000
-#define CFG_ENV_SIZE 0x2000
-#define CFG_ENV_IS_IN_FLASH
+#define CONFIG_ENV_ADDR 0xff820000
+#define CONFIG_ENV_SECT_SIZE 0x10000
+#define CONFIG_ENV_SIZE 0x2000
+#define CONFIG_ENV_IS_IN_FLASH
#else /* CONFIG_MONITOR_IS_IN_RAM */
-#define CFG_ENV_OFFSET 0x4000
-#define CFG_ENV_SECT_SIZE 0x2000
-#define CFG_ENV_IS_IN_FLASH
+#define CONFIG_ENV_OFFSET 0x4000
+#define CONFIG_ENV_SECT_SIZE 0x2000
+#define CONFIG_ENV_IS_IN_FLASH
#endif /* !CONFIG_MONITOR_IS_IN_RAM */
-#define CFG_PROMPT "=> "
-#define CFG_LONGHELP /* undef to save memory */
+#define CONFIG_SYS_USE_PPCENV /* Environment embedded in sect .ppcenv */
+
+#define CONFIG_SYS_PROMPT "=> "
+#define CONFIG_SYS_LONGHELP /* undef to save memory */
#if defined(CONFIG_CMD_KGDB)
-#define CFG_CBSIZE 1024 /* Console I/O Buffer Size */
+#define CONFIG_SYS_CBSIZE 1024 /* Console I/O Buffer Size */
#else
-#define CFG_CBSIZE 256 /* Console I/O Buffer Size */
+#define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */
#endif
-#define CFG_PBSIZE (CFG_CBSIZE+sizeof(CFG_PROMPT)+16) /* Print Buffer Size */
-#define CFG_MAXARGS 16 /* max number of command args */
-#define CFG_BARGSIZE CFG_CBSIZE /* Boot Argument Buffer Size */
+#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */
+#define CONFIG_SYS_MAXARGS 16 /* max number of command args */
+#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */
-#define CFG_LOAD_ADDR 0x00100000
+#define CONFIG_SYS_LOAD_ADDR 0x00100000
-#define CFG_MEMTEST_START 0x400
-#define CFG_MEMTEST_END 0x380000
+#define CONFIG_SYS_MEMTEST_START 0x400
+#define CONFIG_SYS_MEMTEST_END 0x380000
-#define CFG_HZ (50000000 / 64)
-#define CFG_CLK 100000000
+#define CONFIG_SYS_HZ (50000000 / 64)
+#define CONFIG_SYS_CLK 100000000
-#define CFG_MBAR 0x40000000 /* Register Base Addrs */
+#define CONFIG_SYS_MBAR 0x40000000 /* Register Base Addrs */
/*
* Ethernet
*/
-#define FEC_ENET
-#define CONFIG_NET_RETRY_COUNT 5
-#define CFG_ENET_BD_BASE 0x480000
-#define CFG_DISCOVER_PHY 1
-#define CONFIG_MII 1
+#define CONFIG_MCFFEC
+#ifdef CONFIG_MCFFEC
+# define CONFIG_MII 1
+# define CONFIG_MII_INIT 1
+# define CONFIG_SYS_DISCOVER_PHY
+# define CONFIG_SYS_RX_ETH_BUFFER 8
+# define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
+
+# define CONFIG_SYS_FEC0_PINMUX 0
+# define CONFIG_SYS_FEC0_MIIBASE CONFIG_SYS_FEC0_IOBASE
+# define MCFFEC_TOUT_LOOP 50000
+/* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */
+# ifndef CONFIG_SYS_DISCOVER_PHY
+# define FECDUPLEX FULL
+# define FECSPEED _100BASET
+# else
+# ifndef CONFIG_SYS_FAULT_ECHO_LINK_DOWN
+# define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
+# endif
+# endif /* CONFIG_SYS_DISCOVER_PHY */
+#endif
/*
* Definitions for initial stack pointer and data area (in DPRAM)
*/
-#define CFG_INIT_RAM_ADDR 0x20000000
-#define CFG_INIT_RAM_END 0x1000 /* End of used area in internal SRAM */
-#define CFG_GBL_DATA_SIZE 64 /* size in bytes reserved for initial data */
-#define CFG_GBL_DATA_OFFSET (CFG_INIT_RAM_END - CFG_GBL_DATA_SIZE)
-#define CFG_INIT_SP_OFFSET CFG_GBL_DATA_OFFSET
+#define CONFIG_SYS_INIT_RAM_ADDR 0x20000000
+#define CONFIG_SYS_INIT_RAM_SIZE 0x1000 /* Size of used area in internal SRAM */
+#define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
+#define CONFIG_SYS_INIT_SP_OFFSET CONFIG_SYS_GBL_DATA_OFFSET
/*
* Start addresses for the final memory configuration
* (Set up by the startup code)
- * Please note that CFG_SDRAM_BASE _must_ start at 0
+ * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0
*/
-#define CFG_SDRAM_BASE 0x00000000
-#define CFG_SDRAM_SIZE 16 /* SDRAM size in MB */
-#define CFG_FLASH_BASE 0xff800000
+#define CONFIG_SYS_SDRAM_BASE 0x00000000
+#define CONFIG_SYS_SDRAM_SIZE 16 /* SDRAM size in MB */
+#define CONFIG_SYS_FLASH_BASE 0xff800000
#ifdef CONFIG_MONITOR_IS_IN_RAM
-#define CFG_MONITOR_BASE 0x20000
+#define CONFIG_SYS_MONITOR_BASE 0x20000
#else /* !CONFIG_MONITOR_IS_IN_RAM */
-#define CFG_MONITOR_BASE (CFG_FLASH_BASE + 0x400)
+#define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE + 0x400)
#endif /* CONFIG_MONITOR_IS_IN_RAM */
-#define CFG_MONITOR_LEN 0x20000
-#define CFG_MALLOC_LEN (256 << 10)
-#define CFG_BOOTPARAMS_LEN (64*1024)
+#define CONFIG_SYS_MONITOR_LEN 0x20000
+#define CONFIG_SYS_MALLOC_LEN (256 << 10)
+#define CONFIG_SYS_BOOTPARAMS_LEN (64*1024)
/*
* For booting Linux, the board info and command line data
* have to be in the first 8 MB of memory, since this is
* the maximum mapped by the Linux kernel during initialization ??
*/
-#define CFG_BOOTMAPSZ (8 << 20) /* Initial Memory map for Linux */
+#define CONFIG_SYS_BOOTMAPSZ (CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20))
/* FLASH organization */
-#define CFG_MAX_FLASH_BANKS 1 /* max number of memory banks */
-#define CFG_MAX_FLASH_SECT 128 /* max number of sectors on one chip */
-#define CFG_FLASH_ERASE_TOUT 1000
+#define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max number of memory banks */
+#define CONFIG_SYS_MAX_FLASH_SECT 128 /* max number of sectors on one chip */
+#define CONFIG_SYS_FLASH_ERASE_TOUT 1000
-#define CFG_FLASH_SIZE 0x800000
+#define CONFIG_SYS_FLASH_SIZE 0x800000
/*
- * #define CFG_FLASH_USE_BUFFER_WRITE 1
+ * #define CONFIG_SYS_FLASH_USE_BUFFER_WRITE 1
*/
/* Cache Configuration */
-#define CFG_CACHELINE_SIZE 16
+#define CONFIG_SYS_CACHELINE_SIZE 16
+
+#define ICACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \
+ CONFIG_SYS_INIT_RAM_SIZE - 8)
+#define DCACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \
+ CONFIG_SYS_INIT_RAM_SIZE - 4)
+#define CONFIG_SYS_ICACHE_INV (CF_CACR_CINV | CF_CACR_INVI)
+#define CONFIG_SYS_CACHE_ACR0 (CONFIG_SYS_SDRAM_BASE | \
+ CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \
+ CF_ACR_EN | CF_ACR_SM_ALL)
+#define CONFIG_SYS_CACHE_ICACR (CF_CACR_CENB | CF_CACR_CINV | \
+ CF_CACR_DISD | CF_CACR_INVI | \
+ CF_CACR_CEIB | CF_CACR_DCM | \
+ CF_CACR_EUSP)
/* Port configuration */
-#define CFG_FECI2C 0xF0
+#define CONFIG_SYS_FECI2C 0xF0
/* Dynamic MTD partition support */
-#define CONFIG_JFFS2_CMDLINE
+#define CONFIG_CMD_MTDPARTS
+#define CONFIG_MTD_DEVICE /* needed for mtdparts commands */
+#define CONFIG_FLASH_CFI_MTD
#define MTDIDS_DEFAULT "nor0=idmr-0"
#define MTDPARTS_DEFAULT "mtdparts=idmr-0:128k(u-boot)," \
"-(user)";
#if defined(CONFIG_CMD_MII)
-#error MII commands don't work on iDMR board and sholud not be enabled.
+#error "MII commands don't work on iDMR board and should not be enabled."
#endif
#endif /* _IDMR_H */
projects / karo-tx-uboot.git / blobdiff